Total nitrogen removal by Fe-activated carbon composite coupled with persulfate

Weishi Huang,Chenxi Wu,Minghao Gou,Xiaochun Wu,Le Zhang,Ting Liu,Jianlong Wang

DOI: https://doi.org/10.1016/j.seppur.2024.127131

IF: 8.6

2024-09-01

Separation and Purification Technology

Abstract:The conversion of nitrate nitrogen (NO3 −-N) or ammonia nitrogen (NH4 +-N) to dinitrogen (N2) by chemical process for total nitrogen (TN) removal is meaningful, but still a challenge in wastewater treatment. Herein, zero valent iron (Fe0) loaded active carbon (Fe0@AC) was prepared and used to remove TN from the nitrogen-containing wastewater by an efficient chemical reduction coupled with oxidation process (FeR-PSO). In the step of NO3 −-N reduction by Fe0@AC, Fe0@AC with 25 wt% Fe0 could reduce 100 % NO3 −-N with the initial concentration of 50 mg N/L after 60 min at the Fe0@AC dosage of 9 g/L and initial pH of 3.0, and over 30 % NO3 −-N could be reduced to N2. In the subsequent oxidation step, persulfate (PS) and magnesium oxide (MgO) were introduced into the solution after NO3 −-N reduction to selectively oxidize NH4 +-N to N2. The removal efficiency of NH4 +-N and N2 selectivity after 30 min were 100 % and over 90 %, respectively, at the MgO dosage of 8 g/L and the PS dosage of 20.25 g/L. The developed FeR-PSO process could remove 93.40 % of TN from simulated wastewater, and over 90 % of TN from two actual pickle factory wastewaters. The possible mechanisms of NO3 −-N reduction and NH4 +-N oxidation by FeR-PSO process were proposed. These findings provide new insights for TN removal from NO3 −-N containing wastewater or wastewater containing both NO3 −-N and NH4 +-N by chemical process.

engineering, chemical

What problem does this paper attempt to address?

The paper attempts to address the issue of how to efficiently remove Total Nitrogen (TN) in wastewater treatment. Specifically, the paper focuses on converting nitrate nitrogen (NO3⁻-N) or ammonia nitrogen (NH4⁺-N) into nitrogen gas (N₂) through chemical methods to achieve the removal of total nitrogen from wastewater. Currently, this process still faces challenges, particularly the tendency to produce ammonia nitrogen during the removal of nitrate nitrogen, leading to low efficiency in total nitrogen removal.

To tackle this challenge, the paper proposes a new chemical reduction and oxidation coupling process (FeR-PSO), which uses a composite material of activated carbon loaded with zero-valent iron (Fe0@AC) to efficiently remove total nitrogen from wastewater. The specific steps include:
1. Using Fe0@AC to reduce nitrate nitrogen to nitrogen gas and ammonia nitrogen under acidic conditions.
2. Adding persulfate (PS) and magnesium oxide (MgO) to the reduced solution to selectively oxidize ammonia nitrogen to nitrogen gas under alkaline conditions.

Through this coupling process, the paper aims to improve the efficiency of total nitrogen removal and reduce the generation of by-products, thereby providing a new effective method for the treatment of nitrogen-containing wastewater.