Abstract:<p>Soil compaction has direct effects on soil physical properties (increase in soil strength, bulk density, decrease in total porosity, soil aeration, water infiltration rate, and saturated hydraulic conductivity) often reducing root penetration and plant growth, thereby causing a reduction of soil productivity. However, the presence of compacted layers in rice paddy fields increases the efficiency of the traditional flooding irrigation method. For this reason, the use of monitoring tools to detect depth, &#160;thickness and lateral continuity of compacted soil layers in paddy fields is of crucial importance for the assessment of their irrigation efficiency. Electrical Resistivity Tomography (ERT) is a non-invasive geophysical method which allows to detect soil horizons with different degrees of compaction. Particularly, arrays constituted of short electrodes spaced a few centimeters can be used to investigate with high vertical resolution the soil profile.</p><p>In a sandy loam paddy field located in the Lomellina region (PV; RISTEC project, RDP-EU, Lombardy Region), a surface ERT survey was conducted in February 2019 to verify the effectiveness of this technique in assessing soil compaction. The ERT was carried out with Wenner arrays of 48 electrodes spaced 0.1 m along a 5 m transect, to investigate the soil profile up to about 1 m depth in proximity of a soil profile trench dug for soil description and sampling. The results of the traditional soil survey (accurate description of soil horizons, including the compacted layer) were considered as reference data to evaluate the reliability of ERT results. During the ERT survey, soil samples were collected at different depths and distances along the ERT transect: texture, bulk density and porosity were successively measured in laboratory. Moreover, the volumetric soil water content was measured with a probe (ML2 ThetaProbe, Delta-T Devices). Main results show that the correlation between electrical resistivity (ER) and bulk density, soil porosity and volumetric water content is well in line with those observed in recent studies. Data points in the scatter plots are clustered based on the bulk density values; particularly, the cluster corresponding to high bulk density values (i.e. compacted soil) includes the measurement points at the depth where the ERT image shows a greater ER gradient. This depth also corresponds to the compacted layer observed during the investigation of soil profile with traditional methods. These results confirm that compacted layers can be effectively detected in ERT images by identifying depths characterized by higher ER gradients in soils with a relatively homogeneous soil texture. Consequently, an integrated approach combining surface ERT and soil sampling with a hand auger at a few depths to check the texture homogeneity and eventually collect a few soil samples for further analysis (e.g., bulk density, volumetric water content, soil hydraulic conductivity) could be explored to assess the presence and continuity of compacted layers in paddy soils, instead of intensive and extremely invasive surveys.</p>

Considerations on the Electrode-Spacing-to-Electrode-Diameter Ratio in Electrical Resistivity Tomography (ERT): An Operational Approach

Strategy for Optimization of Arbitrary Electrode Distribution for 3D Electrical Resistivity Tomography in Urban Zones

The Study of 3-D Electrical Resistivity Tomography at an Archaeological Site

Analysis Of Integrating Ert Data Of Different Array Types: Simulation Study And Observations On An Archaeological Site

The Selection Strategy of Optimized Arrays for 3-D Electrical Resistivity Tomography

Electrode Configuration Analysis Of Electrical Resistance Tomography Sensor For Subsurface Imaging

Modeling and optimal design of sensor for capacitively coupled electrical resistance tomography system

A novel electrical resistance tomography system based on C4D technique

Research on Parallel Resistance Measurement Principle for Capacitively Coupled Electrical Resistance Tomography

Mapping Soil Layers Using Electrical Resistivity Tomography and Validation: Sandbox Experiments

Resistivity tomography based on multichannel electrodes

Multi-electrode Resistivity Imaging

Electrode array and data density effects in 3D induced polarization tomography and applications for mineral exploration

Conductivity and Electrode Placement Variability: Evaluating the Cramer-Rao Lower Bound in 2D Electrical Impedance Tomography

3D Characterization of Archaeological Remains Buried under Obstacles Using Annular Array Electric Resistivity Tomography

Slope Monitoring Study Using Soil Mechanics Properties and 4-D Electrical Resistivity Tomography Methods

Integration of 2D/3D ground penetrating radar and electrical resistivity tomography surveys as enhanced imaging of archaeological ruins: A case study in San El‐Hager (Tanis) site, northeastern Nile Delta, Egypt

Detection of shallow underground targets using electrical resistivity tomography and the implications in civil/environmental engineering

Laboratory Experiment on 2D Inversion of ERT Data with Different Borehole Arrangements

Surface Electrical Resistivity Tomography: a non-invasive tool to assess the compaction in paddy soils

An Iterative 3D Correction plus 2D Inversion Procedure to Remove 3D Effects from 2D ERT Data along Embankments