Abstract:Nitrogen doping has been always regarded as one of the major factors responsible for the increased catalytic activity of Fe–N–C catalysts in the oxygen reduction reaction, and recently, sulfur has emerged as a co-doping element capable of increasing the catalytic activity even more because of electronic effects, which modify the d-band center of the Fe–N–C catalysts or because of its capability to increase the Fe–Nx site density (SD). Herein, we investigate in detail the effect of sulfur doping of carbon support on the Fe–Nx site formation and on the textural properties (micro- and mesopore surface area and volume) in the resulting Fe–N–C catalysts. The Fe–N–C catalysts were prepared from mesoporous carbon with tunable sulfur doping (0–16 wt %), which was achieved by the modulation of the relative amount of sucrose/dibenzothiophene precursors. The carbon with the highest sulfur content was also activated through steam treatment at 800 °C for different durations, which allowed us to modulate the carbon pore volume and surface area (1296–1726 m2 g–1). The resulting catalysts were tested in O2-saturated 0.5 M H2SO4 electrolyte, and the site density (SD) was determined using the NO-stripping technique. Here, we demonstrate that sulfur doping has a porogenic effect increasing the microporosity of the carbon support, and it also facilitates the nitrogen fixation on the carbon support as well as the formation of Fe–Nx sites. It was found that the Fe–N–C catalytic activity [E1/2 ranges between 0.609 and 0.731 V vs reversible hydrogen electrode (RHE)] does not directly depend on sulfur content, but rather on the microporous surface and therefore any electronic effect appears not to be determinant as confirmed by X-ray photoemission spectroscopy (XPS). The graph reporting Fe–Nx SD versus sulfur content assumes a volcano-like shape, where the maximum value is obtained for a sulfur/iron ratio close to 18, i.e., a too high or too low sulfur doping has a detrimental effect on Fe–Nx formation. However, it was highlighted that the increase of Fe–Nx SD is a necessary but not sufficient condition for increasing the catalytic activity of the material, unless the textural properties are also optimized, i.e., there must be an optimized hierarchical porosity that facilitates the mass transport to the active sites.This article has not yet been cited by other publications.

The interplay between surface area and sulfur doping of carbon support on Pt NPs nucleation and growth: A synergistic enhancement of catalytic activity for oxygen reduction

Self-supporting Nanoporous Gold-Palladium Overlayer Bifunctional Catalysts Toward Oxygen Reduction and Evolution Reactions

Sulfur Doping Triggering Enhanced Pt–N Coordination in Graphitic Carbon Nitride-Supported Pt Electrocatalysts toward Efficient Oxygen Reduction Reaction

Sulfur Doping versus Hierarchical Pore Structure: The Dominating Effect on the Fe–N–C Site Density, Activity, and Selectivity in Oxygen Reduction Reaction Electrocatalysis

Sintering behavior of carbon-supported Pt nanoparticles and the effect of surface overcoating

Interfacial Pt-N Coordination for Promoting Oxygen Reduction Reaction

In-situ observation of defects evolution of graphene nanoflakes in Pt/C catalyst for boosting ORR performance

Anti‐Corrosive SnS2/SnO2 Heterostructured Support for Pt Nanoparticles Enables Remarkable Oxygen Reduction Catalysis via Interfacial Enhancement

The underlying mechanism trade-off between particle proximity effect and low-Pt loading for oxygen reduction and methanol oxidation reaction activity

Strong Metal-Support Interaction Induced by Oxygen Vacancies to Enhance the Activity and Durability of Pt/TiO2/ Hollow Carbon Nanospheres ORR Catalyst

Oxygen Reduction Catalyzed by Pt Nanoparticles Confined in Mesoporous Carbon Supports Doped with Single Fe Atoms

Strong Lewis acid-base interfacial regulation mechanism to reveal oxygen reduction activity origin of N,S-codoped carbon with PtNi particles

Enhanced Stability of Immobilized Platinum Nanoparticles through Nitrogen Heteroatoms on Doped Carbon Supports

Size and near-surface engineering in weak-oxidative confined space to fabricate 4 nm L10-PtCo@Pt nanoparticles for oxygen reduction reaction

Synergistic coupling of P-doped Pd4S nanoparticles with P/S-co-doped reduced graphene oxide for enhanced alkaline oxygen reduction

Influence of a carbon support on the catalytic activity and durability of the Pt-based electrocatalysts

Molecular Insight of the Critical Role of Ni in Pt-Based Nanocatalysts for Improving the Oxygen Reduction Reaction Probed Using an In Situ SERS Borrowing Strategy

Decoupling the Synergy Between PGM and PGM‐Free Moieties toward Oxygen Reduction Reaction

Improving Oxygen Reduction Reaction Performance of Pt by a N-Doping Strategy and Inducing Tensile Strain of Nanoparticles

Insights into the roles of nitrogen and phosphorus co-doping for efficient methanol electrooxidation

Embedding Pt-Ni octahedral nanoparticles in the 3D nitrogen-doped porous graphene for enhanced oxygen reduction activity