Abstract:Upward- (UFS) and downward (DFS) flame spread along a vertical installed electrical wire has been examined experimentally to gain better understandings of the heat transfer mechanism and burning behavior over electrical wires. UFS is considered as a much more hazardous fire scenario than DFS, however, UFS over electrical wires was very limited addressed. Fundamentally, the controlling heat transfer boundary over the preheating zone, hence the flame spread behaviors are quite different between DFS and UFS. This problem is more complicated for an electrical wire, for which the metal conduction is involved additionally, playing an important role in the heat transfer process. Thirteen types of polyethylene-insulated electrical wires with Cu- and NiCr-core were used to investigate the effect of metal core thermal conduction and wire configuration for both UFS and DFS. During the flame spread process, the pyrolysis length of UFS was enlarged, while only portion of virgin material of DFS were burnt as the result of distinct dripping. By further concerning the curvature effect, the dependence of the flame length on heat release rate per unit width (i.e. perimeter for cylinder) can be well explained by non-dimensional analysis. It turns out that the growth of flame length will be restrained as radius decreases significantly, and can be categorized in to two regions, one is controlled by laminar molecular diffusion followed the other controlled by turbulent entrainment. The variation of flame spread rate (FSR) with wire configuration and metal core thermal conduction are well interpreted by a theoretical model, which describes the heat recirculation through flame-insulation-core comprehensively based on thermodynamics theories, and attempts to consider the effects of temperature gap between core and insulation at pyrolysis front, burning fraction and melting heat. The validity of this new model is well confirmed by measured FSR. An important finding is that a highly conductive core will trigger an acceleration of FSR over the wire, primarily because heat flux in gas phase is more sensitive to the change of core thermal conductivity than heat conduction through core. Even though the heat diffusion length increases at the same time, however, the heat flux in gas phase grows faster than the corresponding heat loss through core, thereby compensate the corresponding heat loss. This work could facilitate understanding of heat transfer mechanism and burning behavior not only on the electrical wires, but also on the composite material with high thermal-conductive media.

Experimental study on fire spread behavior of single 110 kV cable under different layout conditions

Influence of Arc Size on the Ignition and Flame Propagation of Cable Fire

Modelling of heat release rate of horizontal cable trays fire in long-narrow confined spaces

Flame Spread Experiments on a Horizontal Preheated Cable Layer

Fire Zone Diagram of Flame-retardant Cables: Ignition and Upward Flame Spread

Fire Behaviors of Flame-Retardant Cables Part I: Decomposition, Swelling and Spontaneous Ignition

Experimental Study on Flammability and Flame Spread Characteristics of Polyvinyl Chloride (PVC) Cable

Effects of interlayer distance and cable spacing on flame characteristics and fire hazard of multilayer cables in utility tunnel

Full-scale Vertical Combustion Test of PVC Cable and Computational Fluid Dynamics Study

Preliminary Real-scale Experimental Studies on Cable Fires in Plenum

Research on the Influence of Auto-Reclosing for Grounding Arc Fault in Cable Tunnel Fire Development

An Enhanced Fire Hazard Assessment Model and Validation Experiments for Vertical Cable Trays

A Comparative Study on Fire Hazards of Cables Used in Nuclear Power Plants Based on Small- and Large-Scale Experiments

Analysis of Upward- and Downward Flame Spread over Vertical Installed Polyethylene-Insulated Electrical Wires

An Experimental Analysis of a Nuclear-Grade Cable Based on Fire Combustion Characteristics and Pyrolysis Behavior

Identification of the Ignition Point of High Voltage Cable Trenches Based on Ceiling Temperature Distribution

Experimental Study of Discharge Properties of High Voltage Transmission Lines and Their Relationship with Fire Parameters under Wildfire Conditions

Simulation Analysis of Temperature Field and Electric Field for 10 kV AC XLPE Cable in DC Operation

Research on Fire Prediction Method of High-Voltage Power Cable Tunnel Based on Abnormal Characteristic Quantity Monitoring

Study on arc duration and erosion characteristics of cable electrodes in AC series circuits

Investigating the Burning Characteristics of Electric Cables Used in the Nuclear Power Plant by Way of 3-D Transient Fds Code