Abstract:The dusty regolith covering the surfaces of asteroids and planetary satellites differs in size, shape, and composition from terrestrial soil particles and is subject to environmental conditions very different from those found on Earth. This regolith evolves in a low ambient pressure and low-gravity environment. Its response to low-velocity impacts, such as those that may accompany human and robotic exploration activities, may be completely different than what is encountered on Earth. Experimental studies of the response of planetary regolith in the relevant environmental conditions are thus necessary to facilitate future Solar System exploration activities.We combined the results and provided new data analysis elements for a series of impact experiments into simulated planetary regolith in low-gravity conditions using two experimental setups and a range of microgravity platforms. The Physics of Regolith Impacts in Microgravity Experiment (PRIME) flew on several parabolic aircraft flights, enabling the recording of impacts into granular materials at speeds of ∼ 4–230 cm/s. The COLLisions Into Dust Experiment (COLLIDE) is conceptually close to the PRIME setup. It flew on the Space Shuttle in 1998 and 2001 and more recently on the Blue Origin New Shepard rocket, recording impacts into simulated regolith at speeds between 1 and 120 cm/s.Results of these experimental campaigns found that there is a significant change in the regolith behavior with the gravity environment. In a 10 −2g environment (with g being the gravity acceleration at the surface of the Earth), only embedding of the impactor was observed and ejecta production was produced for most impacts at > 20 cm/s. Once at microgravity levels (<10−4g), the lowest impact energies also produced impactor rebound. In these microgravity conditions, ejecta started to be produced for impacts at > 10 cm/s. The measured ejecta speeds were somewhat lower than the ones measured at reduced-gravity levels, but the ejected masses were higher. In general, the mean ejecta velocity shows a power-law dependence on the impact energy with an index of ∼ 0.5. When projectile rebound occurred, we observed that its coefficients of restitution on the bed of regolith simulant decrease by a factor of 10 with increasing impact speeds from ∼ 5 up to 100 cm/s. We could also observe an increased cohesion between the JSC-1 grains compared to the quartz sand targets.

Impact response of physical analog of Martian regolith

Centrifuge Modelling of Blast Effects in Dry Sand: Coriolis Effect and Soil Arching

Regolith behavior under asteroid-level gravity conditions: low-velocity impact experiments

Elastic waves generated by impact and vibration in confined granular media

Regolith behavior under asteroid-level gravity conditions: Low-velocity impacts into mm- and cm-sized grain targets

Ejected Particles after Impact Splash on Mars: Aggregates and Aerodynamics

Experimental study on compression property of regolith analogues

Dynamics of sand response to rapid penetration by rigid projectiles

Centrifugal Experiments with Simulated Regolith:Effects of Gravity, Size Distribution, and Particle Shape on Porosity

The Physics of Protoplanetesimal Dust Agglomerates II. Low Velocity Collision Properties

Nonlinear Dynamic Behavior of Cemented Granular Materials under Impact Loading

Damage of Sandstone Induced by Repetitive Impact Loading

A lower-than-expected saltation threshold at Martian pressure and below

Effect of relative density and grain size on the internal flow field during the ballistic penetration of sand

The influence of gravity on granular impacts I. A DEM code performance comparison

Gas permeability and mechanical properties of dust grain aggregates at hyper- and zero-gravity

Experimental and Numerical Study on Ground Shock Propagation in Calcareous Sand

Micro-meteoroid seismic uplift and regolith concentration on kilometric scale asteroids

Hydrocode modeling of the spallation process during hypervelocity impacts: Implications for the ejection of Martian meteorites

Survival of the impactor during hypervelocity collisions II: An analogue for high porosity targets