Efficient hydrogen evolution from water over thin film photocathode composed of solid solutions with a composition gradient of ZnTe and CdTe

Lionel S. Veiga,Hiromu Kumagai,Masakazu Sugiyama,Tsutomu Minegishi,Lionel Sebastian Veiga
DOI: https://doi.org/10.1039/d4se00067f
IF: 6.813
2024-04-06
Sustainable Energy & Fuels
Abstract:Photoelectrodes utilising cadmium telluride (CdTe) have shown promising properties as photocathodes for solar hydrogen evolution from water, such as a large cathodic photocurrent, owing to their long optical absorption edge of about 840 nm, and a large driving force for reaction according to a flat band potential of close to 0.9 VRHE. However, their performance is limited, especially at a relatively high potential region. For the fabrication of a practical photoelectrochemical device, photocathodes with sufficiently high onset potential and high photocurrent at around 0.6 VRHE are desired. In this study, a thin film CdTe based photocathode composed of a bilayer structure with zinc telluride (ZnTe) as the back contact was successfully fabricated by sequential deposition of ZnTe and CdTe using the close space sublimation method. The addition of a small amount of Cu is essential to obtain an efficient photocathode and, interestingly, a composition gradient is introduced through the formation of a solid solution at the ZnTe-CdTe interface. Post deposition rapid thermal annealing further enhanced the cathodic photocurrent resulting in 4.0 mAcm-2 at 0.5 VRHE and a half-cell solar-to-hydrogen conversion efficiency of 3.6% at 0.36 VRHE with incident photon-to-current conversion efficiencies of >70% at 480-640 nm.
materials science, multidisciplinary,chemistry, physical,energy & fuels
What problem does this paper attempt to address?