Abstract:The DarkSHINE experiment aims to search for dark photons by measuring the energy loss of the electrons recoiled from fixed-target. Its electromagnetic calorimeter is primarily responsible for accurately reconstructing the energy of the recoil electrons and bremsstrahlung photons. The performance of the electromagnetic calorimeter is crucial, as its energy measurement precision directly determines the sensitivity to the search for dark photons. The DarkSHINE electromagnetic calorimeter uses LYSO crystals to form a fully absorptive electromagnetic calorimeter. It utilizes SiPMs to detect scintillation light in the crystals, and its readout electronics system deduces the deposited energy in the crystals by measuring the number of photoelectric signals generated by the SiPMs. The DarkSHINE electromagnetic calorimeter aims to operate at an event rate of 1-10 MHz, detecting energies ranging from 1 MeV to 1 GeV. To meet the requirements of high energy measurement precision, high event rate, and large dynamic range, we have researched and designed a readout electronics system based on dual-channel high-speed ADCs and a customized DAQ. The front-end amplification part of this system uses low-noise trans-impedance amplifiers to achieve high-precision waveform amplification. It successfully achieves a dynamic range up to a thousandfold through a double-gain readout scheme. The digital part uses 1 GSPS high-speed ADCs to achieve non-dead-time, high-precision waveform digitization. The DAQ part uses JESD204B high-speed serial protocol to read out the signal from ADC, and transmit it to PC software for processing and storage. Test results show a signal-to-noise ratio greater than 66 dBFS and an ENOB greater than 10.6 bits. Energy spectra measurements have been conducted using LYSO crystals and SiPMs, and an energy resolution of 5.96% at the 2.6 MeV gamma peak of Th-232 has been achieved.

Optimized design and characterization of HYLITE, a charge-integration readout chip of XFEL

A 5.12-Gbps serializer circuit for front-end fast readout electronics of silicon pixelated detectors

Beam instrumentation system for shanghai soft x-ray fel test facility*

High Dynamic Range X-ray Detector Pixel Architectures Utilizing Charge Removal

Design of High-speed readout electronics for the DarkSHINE electromagnetic calorimeter

Design and Evaluation of EMPIX2, a 100 Kfps, High Dynamic Range Pixel Detector Readout ASIC for Electron Microscopy

Design of the AGIPD Sensor for the European XFEL

Optimization of Laser Induced Fluorescence Detection System for Integrated Capillary Electrophoresis Chip

Data Acquisition System for CEPC Vertex Detector Prototype

Prototype of Clock and Timing Distribution and Synchronization Electronics for SHINE

Optimization of the Radiation Hardness of Silicon Pixel Sensors for High X-ray Doses using TCAD Simulations

Resolving soft X-ray photons with a high-rate hybrid pixel detector

Development of the Prototype of the Cavity BPM System for SHINE

EMPIX: A High Dynamic Range Diamond Pixel Detector for Ultra-fast Electron Diffraction and Microscopy

A study of the latest updates of the readout system for the hybird-pixel detector at HEPS

A 64k pixel CMOS-DEPFET module for the soft X-rays DSSC imager operating at MHz-frame rates

The Adaptive Gain Integrating Pixel Detector at the European XFEL

Hammerhead, an ultrahigh resolution ePix camera for wavelength-dispersive spectrometers

Design and beam dynamics simulation for the photoinjector of shanghai soft X-ray free electron laser test facility

Development of a Pixel Readout ASIC for CZT Detectors for Spectral X-ray Photon-Counting Imaging Applications