Pore-Scale Displacement Experiments Using Microfluidic Device to Investigate Fingering Mechanisms Using Both CO2 and N2: Implications for EOR and CO2 Geo-Storage

Duraid Al-Bayati,Matthew Myers,Ali Saeedi
DOI: https://doi.org/10.1134/s0965544124050104
IF: 1.258
2024-09-25
Petroleum Chemistry
Abstract:For water-wet porous media, the literature revealed a poor displacement efficiency for CO 2 relative to N 2 . The overall average residual water saturation displaced by CO 2 is ~50.0% compared to ~20.0% displaced by N 2 . Furthermore, based on the "Land" trapping model (Land, 1968), the non-wetting phase trapped during a subsequent imbibition displacement would also be reduced due to the low end-point saturation of the non-wetting phase achieved during the drainage flood. In this study, we hypothesize that for a drainage flood with a very low viscosity ratio (μ displacing /μ displaced <<1) and low flow rate ( c a < 10 –6 ) (i.e., conditions that are typical for the displacement of water by CO 2 , N 2 in a strongly water-wet porous media) the end-point residual water saturation is predominantly controlled by the interfacial tension of the fluid-gas system. To test our hypothesis, we have performed six pore-scale displacement experiments on a micromodel using both CO 2 and N 2 to understand the influence of different fingering mechanisms (i.e., capillary vs. viscous) on flooding performance. It is observed that, for capillary-dominated floods, IFT values control the displacement efficiency. Therefore, we could conclude for capillary experiments that the poor displacement of the non-wetting (i.e., CO 2 ) is due to a snap-off model which is closely related to the IFT value.
energy & fuels,engineering, chemical,chemistry, physical, petroleum, organic
What problem does this paper attempt to address?