Evaluation of optimal interpolation and segmentation of the optic nerves on magnetic resonance images for cross‐sectional area measurement

Li Sze Chow,Martyn N. J. Paley,Simon J. Hickman
DOI: https://doi.org/10.1002/ima.23030
IF: 2.177
2024-01-30
International Journal of Imaging Systems and Technology
Abstract:Abstract This study investigated nine combination methods produced from three interpolation (Lanczos, iterative curvature based interpolation, and contrast‐guided) and three segmentation (spatial fuzzy C‐means, modified fuzzy C‐means [mFCM], and level set method) models from optic nerve magnetic resonance images (MRI). The aim was to produce sharp edges of the optic nerves for cross‐sectional area measurement. Lanczos‐mFCM was identified as the best combination in terms of: image quality; Dice similarity coefficient; a similar area compared with measurements from raw images but with higher reproducibility; and the highest signal‐to‐noise and contrast‐to‐noise ratios. It was then applied to ten normal datasets. The mean cross‐sectional areas were 12.57 ± 1.92mm 2 from proton density images, 12.98 ± 2.18mm 2 from T2‐weighted (T2W) images including the optic nerve sheath, and 1.68 ± 0.69mm 2 from the T2W images of the optic nerve only. The Lanczos‐mFCM method is recommended for future quantitative studies on optic nerve MRI.
engineering, electrical & electronic,optics,imaging science & photographic technology
What problem does this paper attempt to address?