Abstract:Accurate modelling of spray combustion process is essential for efficiency improvement and emissions reduction in practical combustion engines. In this work, both unsteady Reynolds-averaged Navier-Stokes (URANS) simulations and large eddy simulations (LES) are performed to investigate the effects of spray and turbulence modelling on the mixing and combustion characteristics of an n-heptane spray flame in a constant volume chamber at realistic conditions. The non-reacting spray process is first simulated with URANS to investigate the effects of entrainment gas-jet model on the penetration characteristics and fuel vapor distributions. It is found that the droplet motion near the nozzle has significant influence on the fuel vapor distribution, while the liquid penetration length is controlled by the evaporation process and insensitive to gas-jet model. For the case considered, both URANS with the gas-jet model and large eddy simulations can properly predict the vapor penetration. For the combustion characteristics, it is found that LES yields better predictions in the global combustion characteristics. The URANS with gas jet model yields a comparable flame length and lift-off-length (LOL) to LES, but results in a larger ignition delay time compared to the experimental data. Another focus of this work is to qualify the convergence characteristics of the dynamic adaptive chemistry (DAC) method in these transient combustion simulations, where DAC is applied to reduce the mechanism locally and on-the-fly to accelerate chemistry calculations. The instantaneous flame structures and global combustion characteristics such as ignition delay time, flame lift-off length and emissions are compared between simulations with and without DAC. For URANS, good agreements are observed both on instantaneous flame structures and global characteristics. For LES, it is shown that the errors incurred by DAC are small for scatter distributions in composition space and global combustion characteristics, while they may significantly affect instantaneous flame structures in physical space. The study reveals that for DAC application in transient simulations, global or statistic information should be used to assess the accuracy, such as manifolds in composition space, conditional quantities and global combustion characteristics. For the cases investigated, a speed-up factor of more than two is achieved by DAC with a 92-species skeletal mechanism with less than 0.2 % and 3.0 % discrepancy in ignition delay and LOL, respectively.

Two‐step simulation combining large eddy simulation and population balance Monte Carlo for nanoparticle synthesis in flame spray pyrolysis

Large eddy simulation-bivariate sectional model for non-spherical TiO 2 nanoparticle synthesis in flame

Large Eddy Simulation/dynamic Thickened Flame Modeling of a High Karlovitz Number Turbulent Premixed Jet Flame

Numerical Simulation of Nanoparticle Synthesis in Diffusion Flame Reactor

Direct numerical simulation of three-dimensional swirling n-heptane spray flames

Modeling of Micro- and Nanoparticle Characteristics in DC Suspension Plasma Spray

Studies on a Swirling Heptane Spray Flame by Large-Eddy Simulation

Large Eddy Simulation of Soot Formation in a Turbulent Lifted Flame with a Discretized Population Balance and a Reduced Kinetic Mechanism

Nanoparticles Modeling in Axially Injection Suspension Plasma Spray of Zirconia and Alumina Ceramics

Verification of Size-Resolved Population Balance Modeling for Engineered Nanoparticles under High Concentration

Simulation of Effervescent Atomization and Nanoparticle Characteristics in Radio Frequency Suspension Plasma Spray

Numerical Modeling in Radio Frequency Suspension Plasma Spray of Zirconia Powders

Numerical Investigation of Swirl-Stabilized Pulverized Coal Flames in Air and Oxy-Fuel Atmospheres by Means of Large Eddy Simulation Coupled with Tabulated Chemistry

Effect of Precursor Loading on Non-Spherical TiO2 Nanoparticle Synthesis in a Diffusion Flame Reactor

Population Balance-Monte Carlo Simulation for Gas-to-Particle Synthesis of Nanoparticles

Dynamic Modeling of Micro- and Nano-Sized Particles Impinging on the Substrate During Suspension Plasma Spraying

Combining Langevin Dynamics and CFD-PBM Model to Predict TiO2 Nanoparticle Evolution During Aerosol Synthesis

Flamelet LES of a Turbulent Pulverized Solid Fuel Flame Using a Detailed Phenomenological Soot Model

Flamelet LES of Swirl-Stabilized Oxy-Fuel Flames Using Directly Coupled Multi-Step Solid Fuel Kinetics

Single droplet combustion of precursor/solvent solutions for nanoparticle production: Optical diagnostics on single isolated burning droplets with micro-explosions

Effects of Spray and Turbulence Modelling on the Mixing and Combustion Characteristics of an N -Heptane Spray Flame Simulated with Dynamic Adaptive Chemistry