Abstract:Using 20L explosion vessel, the present research work reports some experimental results which elucidate the effects of dust concentration, particle size and specific surface areas on aluminum dust explosion severity. Dust flame propagation property and explosion products were analyzed systemically. Six kinds of aluminum powders with different size distributions were selected and specially prepared for explosion tests. Results show that explosion parameters present an increasing and then decreasing trend with dust concentrations. The optimum explosion concentrations for all the selected aluminum dusts are similarly equal to 500g/m3. Maximum explosion pressures would be quadratic correlated with the decreasing of particle size. However, (dP/dt)max would be exponentially increasing with particle size decreasing. Aluminum dust flame propagation speed would be increased and the combustion mechanism would be transited from diffusion-controlled mode to kinetically controlled mode with particles diameter decreasing. For the finer dust cloud (dS less than 10μm), dust flame propagation speed would be exponential increased with dust concentration. However, there is a power function relation between flame propagation speeds and dust concentration for the coarse aluminum dust cloud (dS larger than 10μm). At the experimental condition, flame propagation speed presents an exponentially decreased trend with the increasing of particle size. Explosion products obtained at different conditions present different apparent morphology. The higher explosion pressure, the finer explosion fragments and nano-scale spherical structure would be produced. For coarse aluminum particles, explosion products present fluffy flocculent structure. Furthermore, alumina produced under lower explosion pressure conditions are mainly γ-Al2O3 components. Under high explosion pressure condition (such as 0.56MPa), there are notable bulges corresponding to α-Al2O3 are produced. Present research results may have important significance for understanding the explosion mechanism of aluminum-air dust/air cloud.

Blast performance of layered charges enveloped by aluminum powder/rubber composites in confined spaces

Experimental Investigation on the Enhancing Effect of Reactive Materials on Explosion Fireballs and Shock Waves of Composite Charges

Semi‐closed Investigations of New Aluminized Thermobaric and Enhanced Blast Composites

Blast wave characteristics of multi-layer composite charge: Theoretical analysis, numerical simulation, and experimental validation

Blast enhancement from metalized explosives

A Method to Investigate the Confined Explosion of Thermobaric and Enhanced Blast Explosives

Prediction of Peak Overpressure of Charge Enveloped by Polymer Matrix Composite: Theoretical Modeling and Experimental Verification

Variable air blast fireball of HMX/Al with tailored gradient structures

Explosion Temperature and Dispersion Characteristics of Composite Charges Based on Different Non-detonative Materials

Energy output performance of aluminized explosive containing Al/PTFE reactive materials

Effect of metal dust fuel at a low concentration on explosive/air explosion characteristics

Numerical Simulation of the Blast Wave of a Multilayer Composite Charge

Influence of the Hierarchy Structure of Aluminum Particles on Density, Combustion Efficiency, and Ignition Delay

Numerical simulation on the bomb case effects of non‐ideal aluminized explosive

Investigation on Anti-Explosion Performance of Reinforced Concrete Slab with Composite Protective Aluminum Foam

Effect of Mass Ratio on Flame Propagation Behaviors and Thermal Radiation Performance of Al–AlH3 Composite Dust

Energy and blast performance of beryllium in a model thermobaric composition in comparison with aluminum and magnesium

Explosion severity of micro-sized aluminum dust and its flame propagation properties in 20 L spherical vessel

Penetration and jet flame effects induced by the interaction between a new energetic penetrator and a simulated shielding charge

Study on the effect of shape parameters and initiation points of rectangular high explosive on the spatial distribution of blast loads