Abstract:Due to its large reserves, coal is expected to continue to play an important role in the future. However, specific and absolute CO2 emissions are among the highest when burning coal for power generation. Therefore, the capture of CO2 from power plants may contribute significantly in reducing global CO2 emissions. This review deals with the oxyfuel process, where pure oxygen is used for burning coal, resulting in a flue gas with high CO2 concentrations. After further conditioning, the highly concentrated CO2 is compressed and transported in the liquid state to, for example, geological storages. The enormous oxygen demand is generated in an air-separation unit by a cryogenic process, which is the only available state-of-the-art technology. The generation of oxygen and the purification and liquefaction of the CO2-enriched flue gas consumes significant auxiliary power. Therefore, the overall net efficiency is expected to be lowered by 8 to 12 percentage points, corresponding to a 21 to 36% increase in fuel consumption. Oxygen combustion is associated with higher temperatures compared with conventional air combustion. Both the fuel properties as well as limitations of steam and metal temperatures of the various heat exchanger sections of the steam generator require a moderation of the temperatures during combustion and in the subsequent heat-transfer sections. This is done by means of flue gas recirculation. The interdependencies among fuel properties, the amount and the temperature of the recycled flue gas, and the resulting oxygen concentration in the combustion atmosphere are investigated. Expected effects of the modified flue gas composition in comparison with the air-fired case are studied theoretically and experimentally. The different atmosphere resulting from oxygen-fired combustion gives rise to various questions related to firing, in particular, with regard to the combustion mechanism, pollutant reduction, the risk of corrosion, and the properties of the fly ash or the deposits that form. In particular, detailed nitrogen and sulphur chemistry was investigated by combustion tests in a laboratory-scale facility. Oxidant staging, in order to reduce NO formation, turned out to work with similar effectiveness as for conventional air combustion. With regard to sulphur, a considerable increase in the SO2 concentration was found, as expected. However, the H2S concentration in the combustion atmosphere increased as well. Further results were achieved with a pilot-scale test facility, where acid dew points were measured and deposition probes were exposed to the combustion environment. Besides CO2 and water vapour, the flue gas contains impurities like sulphur species, nitrogen oxides, argon, nitrogen, and oxygen. The CO2 liquefaction is strongly affected by these impurities in terms of the auxiliary power requirement and the CO2 capture rate. Furthermore, the impurity of the liquefied CO2 is affected as well. Since the requirements on the liquid CO2 with regard to geological storage or enhanced oil recovery are currently undefined, the effects of possible flue gas treatment and the design of the liquefaction plant are studied over a wide range.

The emissions of NO x , SO 2 , CO and decomposition of carbonates during oxyfuel combustion of low heating value semicoke in CFB pilot facility

Measurements and Modelling of Oxy-Fuel Coal Combustion

Study on the Oxy-Fuel Co-Combustion of Coal Gangue and Semicoke and the Pollutants Emission Characteristics

Ignition and Combustion Behaviors of Single Coal Slime Particles in CO2/O2 Atmosphere

Experimental evaluation of rich oxyfuel combustion characteristics in varying over-stoichiometric conditions

Investigation on Co-Gasification Characteristics of Semicoke and Bituminous Coal in a CO2 Atmosphere at High Temperatures

Structure and combustion characteristics of semi-cokes from a pilot-scale entrained flow gasifier using oxygen-enriched air

Thermal Conversion Property and NO Emission Characteristics of Oxy-Fuel Co-Combustion of Biomass and Semicoke

Investigation on co-combustion of semi-coke and bituminous coal in oxygen-enriched atmosphere: Combustion, thermal conversion, and kinetic analyses

Investigation of Air-Mild and Oxy-Mild Combustion Characteristics of Semicoke and Bituminous Coal Mixtures in a 0.3 MW Fuel-Rich/lean Fired Furnace

Thermogravimetric study on oxy-fuel co-combustion characteristics of semi-coke and antibiotic filter residue

Experimental Study on the Ash Deposition and NO Emission of High-Alkali Coal under the Staged O2/CO2 and O2/RFG Conditions

Effect of demineralization on pyrolysis semi-coke physical and chemical characteristics and oxy-fuel combustion characteristics

The oxycoal process with cryogenic oxygen supply

Simultaneous Investigation of Coal Ignition and Soot Formation in Two-Stage O2/N2 and O2/CO2 Atmospheres

Numerical simulation of O2/CO2 combustion in decomposition furnace

Computational Fluid Dynamics Simulation on Oxy-Fuel Combustion Performance of a Multiple-Burner Furnace Firing Coking Dry Gas

Oxy-fuel Co-Combustion Properties and N-containing Pollutants Release Characteristics of Biomass/coal Blends

Numerical Simulation on Co-Firing Ultra-Low Volatile Carbon-Based Fuels with Bituminous Coal under Oxy-Fuel Condition

Experimental Investigation on NOx Generation Characteristic and Burnout Performance of Co-Combustion of Carbon-Based Solid Fuels under Deep-Staged Combustion

Evaluation of reaction mechanisms and emissions of oily sludge and coal co-combustions in O2/CO2 and O2/N2 atmospheres