A novel intumescent flame-retardant to inhibit the spontaneous combustion of coal

Bing-Rui Yan,Xiang-Ming Hu,Wei-Min Cheng,Yan-Yun Zhao,Wei Wang,Yun-Tao Liang,Tong-Yu Liu,Yue Feng,Di Xue
DOI: https://doi.org/10.1016/j.fuel.2021.120768
IF: 7.4
2021-08-01
Fuel
Abstract:<p>The present paper proposes an intumescent flame-retardant, which is suitable for the entire process of spontaneous combustion of coal. Scanning electron microscopy (SEM), simultaneous thermal analysis, <em>in situ</em> FTIR, and temperature programmed experiment were adopted to analyze its inhibiting effect and mechanism. The results indicate that the flame-retardant can play good inhibitory effects during all stages of coal oxidation and decomposition. In the low-temperature stage of 30–120 °C, the flame-retardant carries a lot of water and the surface temperature of coal is reduced since the evaporation of water removes heat. Meanwhile, the hydroxyl groups in the flame-retardant can connect with the -COO- groups on the surface of coal through hydrogen bonds, and enhance the stability of coal. With the temperature increase, some interlamellar water molecules in Mg-Al-CO<sub>3</sub> layered double hydroxides (LDHs) are removed, which reduces the surface temperature of coal. When the temperature is higher than 170 °C, the IFR/LDH undergoes alcholysis and expands, releasing a large amount of non-flammable gas to dilute the oxygen around coal. When the temperature reaches 300 °C, the expanded foam layer is carbonized and forms a porous char layer, thereby inhibiting the combustion. The CO release of coal sample with flame retardant reduces significantly. The temperature with the maximum weight loss rate increases by 50–70 °C, while the heat release reduces by 11.1–24.2%. After calcination at 500 °C for 30 min, the carbon residue is more than 1.6 times that of the untreated coal sample.</p>
energy & fuels,engineering, chemical
What problem does this paper attempt to address?