Elastic-electro-mechanical modeling and analysis of piezoelectric metamaterial plate with a self-powered synchronized charge extraction circuit for vibration energy harvesting

Zhongsheng Chen,Yemei Xia,Jing He,Yeping Xiong,Gang Wang
DOI: https://doi.org/10.1016/j.ymssp.2020.106824
IF: 8.4
2020-09-01
Mechanical Systems and Signal Processing
Abstract:<p>Structural vibrations usually exist in the form of low-frequency and broadband elastic waves, so cantilever-like harvesters are not appropriate due to space limitations and high quality factor. Piezoelectric metamaterial plate with local resonators (PMP-LR) has been explored to overcome it. However, how to model and analyze the whole energy harvesting system is still a challenge. In this paper, a self-powered synchronized charge extraction circuit is presented and connected to the PMP-LP as the interface circuit. An elastic-electro-mechanical model is built based on the Kirchhoff plate theory and equivalent impedance method, where equivalent impedance of the self-powered synchronized charge extraction circuit is first derived. Then the elastic-electro-mechanical model is numerically solved by using the Bloch theorem and wave finite element method. By numerical simulations, it is found that the synchronized charge extraction circuit has few effects on vibration bandgaps of the PMP-LR. While by inserting an inductor (<span class="math"><math>Lr</math></span>) parallel with the clamped capacitor (<span class="math"><math>Cp</math></span>) of the piezoelectric patch, we can see that a new dispersion curve is induced by the <span class="math"><math>Lr-Cp</math></span> electrical resonance and the inductor is beneficial for low-frequency and broadband vibration energy harvesting. In particular, the inductor can greatly improve the harvesting performance when the resonant frequency is equal to the excitation frequency. In the end, experiments are done and the results are consistent with the numerical ones. Excitingly, the output voltage amplitude of the piezoelectric patch is enlarged about 200% after using the resonant inductor.</p>
engineering, mechanical
What problem does this paper attempt to address?
The problem that this paper attempts to solve is how to effectively model and analyze the performance of the entire system in the structural vibration energy harvesting system, especially for low - frequency and broadband vibrations. Traditional cantilever - beam - type energy harvesters have limitations in practical applications due to space limitations and high Q - values (i.e., narrow - band responses). For this reason, researchers have explored the method of combining piezoelectric metamaterial plates with local resonators (PMP - LR) to overcome these limitations. However, how to model and analyze the entire PMP - LR system including the self - powered synchronous charge extraction circuit (SCEC) remains a challenge. Specifically, this paper proposes a self - powered synchronous charge extraction circuit and connects it to PMP - LR as an interface circuit. Based on Kirchhoff plate theory and the equivalent impedance method, an electro - elastic - mechanical model is established, and the equivalent impedance of the self - powered synchronous charge extraction circuit is derived for the first time. Then, the Bloch theorem and the wave finite element method are used to numerically solve this electro - elastic - mechanical model. Through numerical simulation, it is found that the synchronous charge extraction circuit has little influence on the vibration bandgap of PMP - LR. By inserting an inductor \(L_r\) in parallel with the clamping capacitance \(C_p\) of the piezoelectric patch, a new dispersion curve caused by the electrical resonance of \(L_r/C_0C_p\) can be observed, which is beneficial for low - frequency and broadband vibration energy harvesting. In particular, when the resonance frequency is equal to the excitation frequency, the inductor can significantly improve the energy harvesting performance. The experimental results verify the conclusions of the numerical simulation. After using the resonant inductor, the output voltage amplitude of the piezoelectric patch increases by approximately 200%.