Plate microstructures with extreme stiffness for arbitrary multi-loadings

Yiqiang Wang,Jeroen P. Groen,Ole Sigmund

DOI: https://doi.org/10.1016/j.cma.2021.113778

IF: 6.588

2021-08-01

Computer Methods in Applied Mechanics and Engineering

Abstract:<p><span><span>Mechanical metamaterials that achieve ultimate <a href="/topics/engineering/anisotropic">anisotropic</a><span> stiffness are highly desired in engineering practice. Particularly, the plate microstructures (PM) that are comprised of 6 sets of flat plates have been proved to attain any extreme stiffness in theory. In this paper, we solve two remaining issues for design of optimal PMs. On one hand, we investigate the stiffness <a href="/topics/engineering/optimality">optimality</a> of three PMs that involve fewer than 6 freely-oriented plate sets subjected to any prescribed multi-loadings, which are typically quasiperiodic. Because they have </span></span><a href="/topics/engineering/simple-geometry">simpler geometries</a> with fewer plate sets, they are preferred in practical applications. On the other hand, we identify two optimal periodic plate </span><a href="/topics/mathematics/lattices">lattice</a> structures which are comprised of 7 plate sets, and demonstrate that they are able to attain near-optimal stiffness (over 97% and 99% of the extreme stiffness in theory) for any multi-loadings in the low volume fraction limit. In order to ensure a sufficiently large loading space for verification of the stiffness optimality of these PMs, tens of thousands of random multi-loadings are first used and further the worst multi-loading that yields the highest stiffness deficiency is systematically identified for each PM. The numerical results not only illustrate the stiffness optimality of these PMs, but also provide suggestions on selection of the simplest PMs with the fewest plate sets in applications.</p>

mechanics,engineering, multidisciplinary,mathematics, interdisciplinary applications

What problem does this paper attempt to address?

This paper attempts to solve two main problems:

1. **Stiffness optimality of plate microstructures (PMs) with fewer plate sets under arbitrary multiple loads**:
- The paper studied three plate microstructures (PMs) containing 3 to 5 freely - oriented plate sets. These structures are more preferable in practical applications due to their simple geometries and fewer plate sets. However, their stiffness optimality under arbitrary multiple loads has not been verified yet, so there are no clear guidelines for choosing the simplest PMs with the fewest plate sets for applications.

2. **Optimal periodic plate lattice structures (PLSs) that can achieve the ultimate stiffness under arbitrary multiple loads**:
- Since the optimal PMs containing free plate sets are usually quasi - periodic, which means that each plate set will repeat infinitely many times, but these PMs cannot be described in a periodic form, which may limit their use in some applications. Therefore, the paper aims to identify two periodic plate lattice structures (PLSs) containing 7 plate sets, which can achieve near - optimal stiffness (more than 97% and 99% of the theoretical limit stiffness) at the low volume fraction limit.

To verify the stiffness optimality of these PMs and PLSs, the paper used thousands of random multiple loads for testing and further systematically identified the "worst" multiple - load cases that cause the largest stiffness defects. The numerical results not only demonstrate the stiffness optimality of these PMs and PLSs but also provide suggestions for choosing the simplest PMs with the fewest plate sets in applications.