Power hardware in the loop methodology applied in the integration of wind energy conversion system under fluctuations: a case study

Valery Rubí Rosales-Valladares,Nadia Maria Salgado-Herrera,Osvaldo Rodríguez-Hernández,Juan Ramón Rodríguez-Rodríguez,David Granados-Lieberman,Olimpo Anaya-Lara
DOI: https://doi.org/10.1080/15567036.2024.2308646
2024-01-31
Energy Sources Part A Recovery Utilization and Environmental Effects
Abstract:In this paper, a power hardware in the loop (p-HIL) validation of a wind energy conversion system (WECS) interconnected into the balanced or unbalanced grid is presented. WECS power is obtained from wind fluctuations of the Yucatan Peninsula, Mexico, and transferred through the DC-AC power electronic converter (PEC). A robust control law based on a simple PI regulator and phasor analysis is proposed, having advantages, such as continuous power generation, operating both under balanced and unbalanced grid conditions; total harmonic distortion (THD) reduction less than 3%; power factor (PF) correction close to the unit; balanced grid currents; a simple mathematical analysis. The main objective is to keep the WECS connected to the electrical grid even in the presence of unbalanced three-phase voltages, including contributions such as: i ) VDC ripple reduction; ii ) Balanced currents; iii ) Sinusoidal currents; iv ) Free of Sequence calculation; v ) Free of dq0 or αβ Transforms; vi ) Simple PI Loop control; and vii ) Experimental Validation. The WECS efficiency and robustness are assessed by a complete mathematical examination, validated by the simulations in MATLAB-Simulink®, and support with experimental results through the real-time simulator Opal-RT Technologies®, a low-scale laboratory prototype, and p-HIL methodology. The results present a DC link voltage constant at 75 V and optimal and reliable power integration with an efficiency of 95%.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?