Conversion of Dielectric Surface Effect into Volume Effect for High Output Energy
Shaoke Fu,Huiyuan Wu,Wencong He,Qianying Li,Chuncai Shan,Jian Wang,Yan Du,Shihe Du,Zhengyong Huang,Chenguo Hu
DOI: https://doi.org/10.1002/adma.202302954
IF: 29.4
2023-06-25
Advanced Materials
Abstract:Improving the output energy and durability remains a considerable challenge for the practical applications of triboelectric nanogenerator (TENGs). Owing to the interface effect of triboelectrification and electrostatic induction, thinner films with higher dielectric constants yield a higher output; however, they are not durable for practical applications. Herein, we change the dielectric surface effect into a volume effect by adopting a millimeter‐thick dielectric film with an inner porous network structure so that charges can hop in the surface state of the network. Charge migration inside the dielectric film is the key factor affecting the output of TENGs with a thick film, based on which each working stage follows the energy‐maximization principle in the voltage‐charge plot. The maximum peak and average power densities of TENGs with polyurethane foam film in 1 mm thickness reached 40.9 and 20.7 W m−2 Hz−1, respectively, under environmental conditions, and the output charge density was 5.14 times that of TENGs with a polytetrafluoroethylene film of the same thickness. Super durability was achieved in the rotary‐mode TENG after 200,000 operation cycles. This study identified the physical mechanism of the thick dielectric film used in TENGs and provided a new approach to promote the output and durability of TENGs. This article is protected by copyright. All rights reserved
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,nanoscience & nanotechnology