Optimization of an Aptamer Against Prorocentrum Minimum – A Common Harmful Algae by Truncation and G-quadruplex-forming Mutation
Fuguo Liu,Chunyun Zhang,Yu Duan,Yuanyuan Wang,Guofu Chen
DOI: https://doi.org/10.1016/j.envres.2022.115099
2022-01-01
SSRN Electronic Journal
Abstract:Harmful algal blooms (HABs) caused by Prorocentrum minimum have seriously posed economic losses and ecological disasters. To reduce these losses, aptamers are used as a new molecular probe to establish rapid methods. Herein, to improve the affinity and application of aptamers in the detection of harmful algae, the optimization was performed on the previously reported aptamers against P. minimum. First, a total of seven candidate aptamers, including three truncated aptamers (TA1, TA2 and TA3) and four mutant aptamers (MA1, MA2, MA3 and MA4), were obtained by truncation and G-quadruplex (GQ)-forming mutation. Next, the specificity and affinity test by flow cytometry revealed that except for TA1 and TA2, all of the candidate aptamers are specific with the equilibrium dissociation constant of (40.4 ± 5.5) nM for TA3, (63.3 ± 24.0) nM for MA1, (71.7 ± 14.6) nM for MA2, (365.9 ± 74.4) nM for MA3, and (21.1 ± 0.5) nM for MA4, respectively. The circular dichroism analysis of the mutant aptamers demonstrated that the GQ structures formed by MA1/MA2, MA3 and MA4 were antiparallel, mixed parallel and parallel, respectively. The affinity of aptamers with various GQ is in the order of parallel structure > antiparallel structure > mixed parallel structure. In addition, to further improve binding ability, the binding conditions of MA4 were optimized as follows: binding time, 60 min; binding temperature, 37 °C; pH of the binding buffer, 7.5; and Na+/Mg2+ concentration in the binding buffer, 100 mM/0.5 mM. The binding examination by fluorescence microscopy showed that MA4 had a stronger binding ability to P. minimum than the original aptamer. Taken together, this study not only obtained an aptamer with higher affinity than the original aptamer, which laid a good foundation for subsequent application, but also may provide a feasible reference method for aptamer optimization.