Abstract:A line-based fiber optic sensor, modified from the loop-based configuration of the Sagnac interferometer using a Faraday rotator mirror (FRM), is easy to set the sensing fiber (SF) in the field application, especially in long-distance perimeter security. The sensor we proposed is composed of two line-based interferometers, which are multiplexed with super luminescent diode (SLD), interference unit (IU) and SF respectively through wavelength division multiplexer (WDM) to obtain different wavelength disturbance signals generated by the same disturbance. Two signals with fixed time delay, determined by the position of the disturbance and extracted by signal correlation method, are obtained. Then the position of disturbance can be calculated by it. Experiments show that low-frequency noise has a great impact on the positioning results, and even leads to the failure of positioning. In this work, the influence of disturbance frequency and sampling rate on the accuracy of calculation results is analyzed, and two new processing methods is proposed. Firstly, we use bandpass filtering to eliminate the effects of these factors. Disturbances at different locations require different filtering ranges. We propose a method to determine the filter range by null-frequency, which can achieve higher positioning accuracy. Secondly, the sampling rate of 0.5 MHz is raised to 2.5 MHz by using spline interpolation method. The combination of these two methods can achieve higher accuracy and better reliability of positioning results. Experiments results show that the positioning accuracy of this method can be improved from 200 m to 40 m with the total length of SF is 40 km.

High-Precision distributed fiber optic vibration positioning system with grating array

Pattern Recognition Based on Enhanced Multifeature Parameters for Vibration Events in Φ‐otdr Distributed Optical Fiber Sensing System

Distributed Single Fiber Optic Vibration Sensing with High Frequency Response and Multi-Points Accurate Location

A High Performance Distributed Optical Fiber Sensor Based on Φ-OTDR for Dynamic Strain Measurement

Quantitative quasi-distributed vibration sensing by φ-OFDR for multiple events over spatially consecutive sensing spatial resolutions

Distributed Strain and Vibration Sensing System Based on Phase-Sensitive OTDR

Phase Sensitive Distributed Vibration Sensing Based on Ultraweak Fiber Bragg Grating Array Using Double-Pulse

An OTDR and Gratings Assisted Multifunctional Fiber Sensing System

2-Dimensional Timestamp-Based Sliding Window Cross-Correlation Localization Algorithm for Distributed Optical Fiber Vibration Sensing Interferometer

Precision Error Analysis of the Embedded Distributed Optical Fiber Displacement Monitoring

Two-Dimensional Timestamp-Based Sliding Window Cross Correlation Localization Algorithm for Distributed Optical Fiber Vibration Sensing Interferometer

A Distributed Optical Fiber Sensing System for Synchronous Vibration and Loss Measurement

Development of A Distributed Fiber Sensor for Simultaneous Strain and Vibration Measurement

Real-time phase demodulation and data administration of distributed optical fiber vibration sensing system

Improved Location Algorithm for High-spatial-resolution in Fiber Optic Line-based Sensor

Distributed Fiber-optic Vibration Sensor with Enhanced Response Bandwidth and High Signal-to-noise Ratio

A Novel Sagnac Distributed Optical Fiber Vibration Sensor Based on Time Delay Estimation Algorithm

Distributed Dynamic Strain Measurement with a Direct Detection Scheme by Using a Three-Step-phase-shifted Double Pulse in a UWFBG Array

Distributed Fiber-Optic Dynamic-Strain Sensor with Sub-Meter Spatial Resolution and Single-Shot Measurement

Position Determination and Monitoring of Disturbance along Distributed Fiber Optic Sensors

Modulated Pulses Based High Spatial Resolution Distributed Fiber System for Multi-Parameter Sensing