Abstract:Schapery's nonlinear formulation for viscoelastic materials has been successfully used by many investigators at room temperature [1-3]. Little work has been presented in the literature where the above approach is applied to viscoelastic materials at elevated temperature. In the present work, Schapery's constitutive equation is used to study the nonlinear viscoelastic creep response of neat and carbon fiber-reinforced Polyether-etherketone (PEEK) and epoxy resin at different temperatures. As reinforced materials, the laminates [90 4 ] s and [±45 4 ] s were investigated. Series of 10-hour isothermal tensile creep tests were conducted on each laminate at four temperatures (up to 140°C for the epoxy system and up to 120°C for the PEEK system) and different stress levels. For comparison reasons the same type of experiments was conducted on the respective neat polymers. Schapery's approach was used to characterize the nonlinear viscoelastic response of the above materials. The stress and temperature dependence of the nonlinearity factors was evaluated using a numerical procedure based on least squares techniques. The results show that the linear viscoelastic limit is shifted to lower values with increasing temperature. This was observed for both neat polymers as well as for the [±45 4 ] s laminates investigated. On the other hand, for the [90 4 ] s laminates the influence of the temperature on the linear viscoelastic limit seems to be relatively restricted. Moreover, for all resins and laminates studied it is shown that the influence of temperature on the nonlinearity of the instantaneous material response is significantly lower than that on the transient nonlinearity. For the investigated temperature range it can therefore be assumed that the instantaneous creep response is linear and independent of temperature over a stress range relevant in practical applications. On the other hand, the influence of temperature on the transient creep response was found to be nonlinear. The transient creep response of the composite materials subjected to intralaminar shear stress showed higher temperature sensitivity than that under normal stress.

Statistical analysis of creep behavior in thermoset and thermoplastic composites reinforced with carbon and glass fibers

Multi-Scale Modelling of Long-Term Mechanical Behaviour in Polymer Composite Laminates with Woven Fibre Architecture

Time-temperature behavior of carbon/epoxy laminates under creep loading

Experimental and Numerical Investigation of Creep Behavior In Isotropic Composites

Characterization of the effect of creep and multiaxial loading situations on fatigue of short fiber reinforced thermoplastics

Long‐term creep deformation of carbon fiber/epoxy composites with physical aging: Experimental investigation and constitutive modeling

Modeling creep behavior of carbon nanotube/fiber/polymer composite cylinders

Creep-fatigue and Cyclically Enhanced Creep Mechanisms in Aluminium Based Metal Matrix Composites

Characterization of nonlinear viscoelastic behaviors of CF/EP laminates with consideration to physical aging effect under thermo-mechanical loading

Cyclic creep strain rate criterion for short-fibre reinforced thermoplastics: Validation of creep and fatigue performance across a wide range of load ratios

Creep and Recovery Behavior of Continuous Fiber-Reinforced 3DP Composites

Temperature-dependent creep damage mechanism and prediction model of fiber-reinforced phenolic resin composites

Creep modeling of composite materials based on improved gene expression programming

Analysis and numerical investigations on the temperature-dependent creep behavior of polypropylene matrix composite used for coating of offshore pipeline

On the Creep Fatigue Behavior of Metal Matrix Composites

Prediction of creep failure life for unidirectional CFRP with heat-resistant epoxy resin as matrix exposed to high temperature under tension load

Evaluation of Tensile properties of FRP Composite Laminates under Varying Strain Rates and Temperatures

Polymer-Matrix Composites: Characterising the Impact of Environmental Factors on Their Lifetime

On the Effect of Temperature on the Creep Behavior of Neat and Carbon Fiber Reinforced PEEK and Epoxy Resin

Elevated-Temperature Creep Buckling of Thermoplastic-Matrix Fiber Composites under Biaxial Loading

Predictive Model for Creep Behavior of Composite Materials Using Gene Expression Programming