Abstract:Reconfigurable Intelligent Surfaces (RIS) have received significant attention recently as an innovation for enhanced connectivity, capacity, and energy efficiency in future wireless networks. Recent works indicate that such RIS-augmented communications can significantly enhance performance by intelligently shaping the characteristics of the multipath propagation environment to focus the energy in a desired direction and to circumvent impediments such as blockage, especially for communication at millimeter-wave (mmW), Terahertz (THz) and higher frequencies. In this paper, we investigate optimized (amplitude and phase) RIS design in a point-to-point multipath MIMO link and study the impact on link capacity under the assumption of perfect channel state information at the transmitter (TX), receiver (RX) and RIS. Specifically, we propose RIS design based on the maximization of the trace of the composite TX-RIS-RX link matrix which is a measure of the average power at the RX. We propose two RIS designs: a diagonal RIS matrix, and a general RIS matrix representing a more advanced architecture. The optimum design, in both cases, corresponds to calculating the dominant eigenvector of certain Hermitian matrices induced by the component channel matrices. We illustrate the capacity performance of the optimized RIS designs and compare them to a baseline design (random amplitudes and phases) and a recently proposed low-complexity phase-only design. We present results for sparse and rich multipath, and also consider the impact of line-of-sight paths. Our results show that while all designs offer comparable capacity at high signal-to-noise ratios (SNRs), the proposed optimum designs offer substantial gains at lower SNRs.

RIS Optimization on the Complex Circle Manifold for Interference Mitigation in Interference Channels

Reconfigurable Intelligent Surface for Interference Alignment in MIMO Device-to-Device Networks

Sum-Rate Maximization for RIS-Assisted Integrated Sensing and Communication Systems with Manifold Optimization.

Achievable Rate Region of Active RIS-Aided MISO Interference Channels

Physically-Consistent Modeling and Optimization of Non-local RIS-Assisted Multi-User MIMO Communication Systems

MMSE Design of RIS-aided Communications

On Spatial Multiplexing Using Reconfigurable Intelligent Surfaces

Multi-Functional RIS: Signal Modeling and Optimization

Joint Optimization for RIS-Assisted Wireless Communications: From Physical and Electromagnetic Perspectives

Optimization for Reflection and Transmission Dual-Functional Active RIS-Assisted Systems

Interference Exploitation Precoding for Reconfigurable Intelligent Surface Aided Multi-User Communications With Direct Links

Integrated Sensing and Communication with Reconfigurable Intelligent Surfaces

Ergodic Achievable Rate Analysis and Optimization of RIS-assisted Millimeter-Wave MIMO Communication Systems

Reconfigurable Intelligent Surface (RIS)-Enhanced Two-Way OFDM Communications

Joint MIMO Transceiver and Reflector Design for Reconfigurable Intelligent Surface-Assisted Communication

Millimeter Wave Communications With Reconfigurable Intelligent Surfaces: Performance Analysis and Optimization

Interference Leakage Minimization in RIS-assisted MIMO Interference Channels

RIS-Aided Multiuser MIMO-OFDM with Linear Precoding and Iterative Detection: Analysis and Optimization

Low-Complexity Channel Estimation and Passive Beamforming for RIS-Assisted MIMO Systems Relying on Discrete Phase Shifts

Optimization of Reconfigurable Intelligent Surfaces Through Trace Maximization

RIS-assisted Millimeter-Wave MIMO Communication Systems: Ergodic Capacity Analysis and Optimization.