Heterogeneous activation of permonosulfate by biochar supporting CuCoFe layered double hydroxide for rapid degradation of phenanthrene

Lin Wu,Tao Jin,Dan Li,Liping Wang,Yichen Sun
DOI: https://doi.org/10.1016/j.jece.2023.110718
IF: 7.7
2023-08-14
Journal of Environmental Chemical Engineering
Abstract:In this study, a ternary layered double hydroxide (CuCoFe-LDH) coated on corn straw-based biochar (BC@LDH) was synthesized and characterized using various approaches. Application in heterogeneous activation of permonosulfate (PMS) for the degradation of phenanthrene (PHE) suggested that the higher Co content in the material, the higher the catalytic activity, maximum of which was 96.5% reached at catalytic dosage of 0.2 g/L, PMS concentration of 2.0 mmol/L, pH 7 and temperature of 45 °C within 15 min in BC 1 @LDH 1 (BC to mass ratio of 1:1)/PMS system. Improved PHE degradation and wide pH application range supported that BC not only acted as CuCoFe-LDH carrier, but also probably participated in the activation of PMS due to abundant functional groups, like hydroxyl as FT-IR revealed. Co-existing ions (NO 3 -, CO 3 2- ) and humic acid (HA), but not Cl - , significantly inhibited PHE degradation. Moreover,the removal of PHE was mainly attributed to SO 4 · - and ·OH, while O 2 · − and 1 O 2 contributed less. It was proposed that Cu (I), Co (II) and Fe (II) were responsible for the PMS activation and produced Co (III) can be reduced by HSO 5 - and Fe (II) to achieve Cu (I)/Co (III) cycle, thereby maintaining high catalytic activity and structural stability of BC 1 @LDH 1 . Remarkably, Consecutive runs (>80.0% PHE removal after 4 cycles) and low level of leaching metal concentration (0.053 mg/L of Co and 0.077 mg/L of Cu at pH 7) all implied that BC 1 @LDH 1 possesses much greater potential in activating PMS for practical application.
engineering, chemical, environmental
What problem does this paper attempt to address?