Abstract:Vessels cause hydrodynamic effects through their motion and propulsion system. In shallow areas, these effects may have an influence on the seabed. Today, knowledge about the influence of the ship traffic on the seabed stability is scarce. Some effects which have to be considered are the currents, the effects of extrusion, waves and the propeller wash. The critical shear stress of the sediments may be exceeded especially by high acceleration rates or by navigation through shallow waters which causes erosion of the bed material and suspended matter in the water column. Additional sedimentation in low current areas can occur. These effects are most pronounced in ports and harbours and shallow navigation channels. To assess the impact of sediment resuspension by ship propellers on larger scales, like, e.g. harbours, or whole rivers, a research programme was defined by HPA (Hamburg Port Authority), MPA (Marine Port Authority, Singapore) and DHI. Hydrodynamic simulations using a programme like MIKE by DHI can be used to simulate the effects of many ships in larger areas. However, an approach like this needs a description of how much a ship is re-suspending throughout its passage of an area. The impact of ship propellers on the resuspension of sediments can be studied theoretically, in physical model tests, or in CFD simulations, all of which have been tested within this project. Two different CFD simulation methods were tested to evaluate the most efficient way of modelling a larger matrix of parameter influencing the bottom shear stress. The MRF method was validated and finally chosen to perform the numerical sensitivity test. It turned out that the number of propeller revolutions per minute is the most important factor for increasing the bottom shear stress and therefore the suspended sediment concentration. Additionally significant suspended sediment concentrations were measured during manoeuvring inside the restricted areas in the ports of Hamburg and Singapore.

Experimental and numerical studies of sediment removal in double bottom ballast tanks

A Subjective Approach for Ballast Water Risk Estimation

Coupled Computational Fluid Dynamics-Discrete Element Method for Simulating the Interactions Between Ship-Induced Waves and Riprap on Restricted Waterway Banks

Laboratory Studies on Nearshore Density-Driven Exchange Flow over a Partly Vegetated Slope

Numerical Simulation of Ballast Water by Sph Method

Experimental investigations and three-dimensional computational fluid dynamics modeling of sediment transport in tanks influenced by cavities

Discharge of ballast residual sediments during de-ballasting procedures: A more realistic estimate of propagule pressure

Effect of Seepage Flow on Sediment Incipient Motion Around a Free Spanning Pipeline

A semi-analytical model for analyzing the transport of organic pollutants through the geomembrane composite cut-off wall and aquifer system

Experimental Study on Microbial Activity of Ship Ballast Water and Corrosion of Ballast Tank by Inert Flue Gas Deoxidation

SEDIMENT RESUSPENSION AND SEABED SCOUR INDUCED BY SHIP-PROPELLER WASH

Numerical analysis of temporal effect of ballast shoulder cleaning

Ballast Water Treatment Performance Evaluation under Real Changing Conditions

CFD analysis of the full-scale resistance of an oil tanker in presence of a mud–water interface

The Numerical Investigation of the Performance of a Newly Designed Sediment Trap for Horizontal Transport Flux

Numerical simulation of damping effect of ballast water system on motion response of immersed tunnel element

Modeling Dynamic Processes of Mondego Estuary and Óbidos Lagoon Using Delft3D

Modification of Ballast Filtering Device on John Lie Training Ship to Prevent Marine Pollution

Feasibility Study on Shore-based Treatment Technology of Ship’s Ballast

Evaluating Different Track Sub-Ballast Solutions Considering Traffic Loads and Sustainability

Effects of ballast transfer on modeling and dynamic responses of a 15MW semi-submersible floating wind turbine