Oxygen reduction reaction platinum group metal-free electrocatalysts derived from spent coffee grounds

Giovanni Zuccante,Maurizio Acciarri,Carmelo Lo Vecchio,Irene Gatto,Vincenzo Baglio,Nicolò Pianta,Riccardo Ruffo,Luciano Navarini,Carlo Santoro
DOI: https://doi.org/10.1016/j.electacta.2024.144353
IF: 6.6
2024-04-30
Electrochimica Acta
Abstract:The annual generation of coffee waste has overtaken 6 million metric tons, becoming a serious environmental problem. Herein, we report the fabrication of bimetallic electrocatalysts synthesized by 1) pyrolyzing spent coffee grounds (SCGs) at 400, 600, 800 and 1000°C, 2) activating the as-obtained char with KOH and 3) functionalizing the activated carbon with iron(II) and manganese(II) phthalocyanine. The final electrocatalysts showed a high degree of amorphousness, defectivity (increasing with temperature) and high specific surface area (up to 1820 m 2 g −1 ). In half-cell compartment (0.1M KOH electrolyte), the top-notch material in terms of oxygen reduction reaction (ORR) activity and selectivity was CFeMn_600, which showed the same half-wave potential (E 1/2 ) compared to Pt/C standard along with a lower peroxide production. These outstanding results could be attributed to a high surface area, a Fe-Mn synergy, and an abundance of C-N defects. The performance of CFeMn_600 as a cathode material in alkaline exchange membrane fuel cells (AEMFC) showed an open circuit voltage (OCV) of 0.890 V and power density of 30 mW cm −2 . Notwithstanding, this research is one of few cases where a waste-derived electrocatalyst is tested in a real AEMFC, thus becoming a pioneer in the fuel cell study of waste-derived electrode materials.
electrochemistry
What problem does this paper attempt to address?