Abstract:The application of seawater as the mixing water in concrete production could mitigate the increasing demand for fresh water in concrete production associated with the continuously increasing offshore infrastructures. Understanding the key factors that influence the properties of seawater-mixed cementitious materials could promote the application of seawater during concrete preparation. A comprehensive investigation was carried out to assess the effects of the water/cement ratio (w/c), the partial replacement of ordinary Portland cement (OPC) with supplementary cementitious materials, and the salt concentration in seawater on the rheological properties (plastic viscosity (η), dynamic yield stress (τd), thixotropic area (Athix)), compressive strength (fc), hydration products and microstructure of cement pastes. The results show that there was an increase in η, τd, Athix and fc in all seawater mixes compared to deionized (DI) water mixes, and the increase in strength was more significant in the pastes with a lower w/c. The increase in salt concentration in the seawater did not linearly increase fc; instead, the early age strength increased initially and then decreased. This result was due to the combined effects of the increased chloride and Na+ ions on the strength development with the increase in salt concentration in the seawater. Interestingly, it was found that there was a good correlation between the results of η and fc for the seawater mixes in this study, and the same η value indicated a higher fc in the seawater mix than in the DI water mix.

Study on the resistance to seawater corrosion of the cementitious systems containing ordinary Portland cement or/and calcium aluminate cement

Study of seawater corrosion resistance of ordinary Portland cement–aluminate cement–gypsum mortar containing slag

Effects of Cyclic Seawater Exposure on the Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete

Study on seawater corrosion resistance of calcium sulfoaluminate cement-based novel grouting materials

Mechanical Performance and Chloride Penetration of Calcium Sulfoaluminate Concrete in Marine Tidal Zone

Development of cementitious capillary crystalline waterproofing agents and durability study of concrete in the presence of chloride with sulfate in aqueous environment

Prolonging the Durability of Maritime Constructions through a Sustainable and Salt-Resistant Cement Composite

Effect of Seawater on Hydration and Sulfate Resistance of Noncement Mortars

Durability of cementitious materials in seawater environment: A review on chemical interactions, hardened-state properties and environmental factors

Concrete Admixed with Modified Auxiliary Cementing Materials for Real Sea Service

Degradation characteristics of Portland cement mortar incorporating supplementary cementitious materials under multi-ions attacks and drying-wetting cycles

Resistance of Chloride and Sulfate of Geopolymer based on fly ash and silica fume as alternative raw materials.

Rheological properties, compressive strength, hydration products and microstructure of seawater-mixed cement pastes

Durability of a new type of cement-based composite grouting material under effects of chemical corrosion

Study of Salt Resistance and Mechanical Strength of Robust and Non-Fluorinated Superhydrophobic Cement

Long-term performance of fiber reinforced cementitious composites with high ductility under seawater attack with different salinities

Effects of w/b ratio, fly ash, limestone calcined clay, seawater and sea-sand on workability, mechanical properties, drying shrinkage behavior and micro-structural characteristics of concrete

Durability and mechanism of high-salt resistance concrete exposed to sewage-contaminated seawater

Corrosion Resistance and Compressive Strength of Cemented Soil Mixed with Nano-Silica in Simulated Seawater Environment

Chloride resistance of class C/class F fly ash-based geopolymer mortars with different strength grades

Chloride penetration resistance and chloride binding capacity under different application environments of ferroaluminate cement