Abstract:Mechanical changes in breast tissues as a result of cancer are usually detected through palpation by the physician and/or self examination. However, physicians are unable to palpate most masses under I cm in diameter and microscopic diseases. The goal of our study is to introduce the application of the Harmonic Motion Imaging (HMI), an acoustic radiation force technique, for reliable sensitive tumor detection and real-time monitoring of tumor ablation. Here, we applied the HMI technique using a single-element Focused Ultrasound (FUS) transducer. Due to the highly localized and harmonic nature of the response, the motion characteristics can be directly linked to the regional tissue modulus. In this experiment, a confocal transducer, combining a 4.68 MHz therapy (FUS) and a 7.5 MHz diagnostic (pulse-echo) probe, was used. The FUS beam was further modulated by a low AM continuous wave at 25 Hz. A pulser/receiver was used to drive the pulse-echo transducer at a Pulse Repetition Frequency (PRF) of 5.4 kHz. The radio-frequency (RF) signals were acquired using a standard pulse-echo technique. The intensity amplitudes of the FUS beam at the focus (I-spta) were 231 W/cm(2) for tumor detection and 1086 W/cm(2) for FUS ablation. An analog bandpass filter was used to remove the spectrum of the FUS beam prior to displacement estimation. The resulting axial tissue displacement (i.e., HMI displacement) was estimated using an RF-based speckle tracking technique based on ID cross-correlation. For tumor mapping, a harmonic radiation force was applied using a 2D raster-scan technique. The 3D HMI image was obtained by combining multiple 2D planes at different depths. The 2D and 3D HMI images in ex vivo breast tissues could detect a benign tumor (2x5x5mm(3)) surrounded by normal tissue, and a malignant tumor (8x7x5mm(3)) embedded in glandular and fat tissues. For FUS therapy, temperature measurements and RF signals were acquired during thermal ablation. HMI images during FUS ablation showed lower displacements, indicating thus tissue hardening due to lesion formation at temperatures higher than 50 degrees C. A finite-element model (FEM) simulation was also used to analyze the findings of the experimental results. In conclusion, this technique demonstrates feasibility of the HMI technique for tumor detection and characterization, as well as real-time monitoring of tissue ablation based on the associated tissue elasticity changes.

Non-Invasive Assessment of the Spatial and Temporal Distributions of Interstitial Fluid Pressure, Fluid Velocity and Fluid Flow in Cancers In Vivo

Estimation of Vascular Permeability in Irregularly Shaped Cancers Using Ultrasound Poroelastography

Non-invasive imaging of interstitial fluid transport parameters in solid tumors in vivo

Non-invasive imaging of Young's modulus and Poisson's ratio in cancers in vivo

Noninvasive Estimation of Tumor Interstitial Fluid Pressure from Subharmonic Scattering of Ultrasound Contrast Microbubbles.

Non-Invasive Imaging of Normalized Solid Stress in Cancers in Vivo

Non-Invasive Imaging of Mechanical Properties of Cancers In Vivo Based on Transformations of the Eshelby's Tensor Using Compression Elastography

Patient-Specific Characterization of Breast Cancer Hemodynamics Using Image-Guided Computational Fluid Dynamics

In Vivo Tumor Interstitial Fluid Pressure Measurement Using Static Micro Force Sensor and Mechanical Tumor Model

Numerical simulation of blood flow and interstitial fluid pressure in solid tumor microcirculation based on tumor-induced angiogenesis

Pattern recognition of microcirculation with super-resolution ultrasound imaging provides markers for early tumor response to anti-angiogenic therapy

Characterization of Spatially Mapped Volumetric Molecular Ultrasound Signals for Predicting Response to Anti-Vascular Therapy

An Insight into Perfusion Anisotropy within Solid Murine Lung Cancer Tumors

Computational Modeling of Interstitial Fluid Pressure and Velocity in Head and Neck Cancer Based on Dynamic Contrast-Enhanced Magnetic Resonance Imaging: Feasibility Analysis

MRI-Based Interstitial Fluid Velocity Analysis for Drug Delivery Efficiency Evaluation in Tumor

3-D Ultrasound Localization Microscopy for Identifying Microvascular Morphology Features of Tumor Angiogenesis at a Resolution Beyond the Diffraction Limit of Conventional Ultrasound

Spatial Characterization of Tumor Perfusion Properties from 3D DCE-US Perfusion Maps Are Early Predictors of Cancer Treatment Response.

Changes in Tissue Fluidity Predict Tumor Aggressiveness In Vivo

Heterogeneous Mechanical Stress and Interstitial Fluid Flow Predictions Derived from DCE-MRI for Rat U251N Orthotopic Gliomas

Mapping Of Regional Cancerous Tissue Mechanical Property Changes Using Harmonic Motion Imaging

A spline interpolation based data reconstruction technique for estimation of strain time constant in ultrasound poroelastography