Thrust production and chordal flexion of the flukes of bottlenose dolphins performing tail stands at different efforts

David A. Kramer,Maura J. Sheehan,Frank E. Fish
DOI: https://doi.org/10.1242/jeb.246228
IF: 3.308
2024-02-21
Journal of Experimental Biology
Abstract:Dolphins have become famous for their abilities to perform a wide variety of athletic and acrobatic behaviors including high speed swimming, maneuverability, porpoising, and tail stands. Tail stands are a behavior where part of the body is held vertically above the water's surface achieved through thrust produced by horizontal tail fluke oscillations. Strong, efficient propulsors are needed to generate the force required to support the weight, exhibiting chordwise and spanwise flexibility throughout the stroke cycle. To determine how thrust production, fluke flexibility, and tail stroke kinematics vary with effort, six adult bottlenose dolphins (Tursiops truncatus) were tested at three different levels based on the position of the center of mass (CM) relative to the water's surface: low (CM below surface), medium (CM at surface), and high (CM above surface). Additionally, fluke flexibility was measured as a flex index (FI=chord length/camber length) at four points in the stroke cycle: center stroke up (CU), extreme top of stroke (ET), center stroke down (CD), and extreme bottom of stroke (EB). Video recordings were analyzed to determine the weight supported above the water (thrust production), peak-to-peak amplitude, stroke frequency, and FI. Force production increased with low, medium, and high efforts, respectively. Stroke frequency also increased with increased effort. Amplitude remained constant with a mean 33.8% of body length. Significant differences were seen in the FI during the stroke cycle. Changes in FI and stroke frequency allowed for increased force production with effort, and the peak-to-peak amplitude was higher compared to horizontal swimming.
biology
What problem does this paper attempt to address?