Abstract:Oxidation of the secondary O–H bond of glycerol to dihydroxyacetone is an important reaction in the production of high-value-added chemicals. The heterogeneous catalytic oxidation route using supported Au as a catalyst in this crucial reaction has attracted considerable attention. However, targeted activation of the secondary O–H bond and satisfactory catalytic efficacy remain considerable challenges. This work reports layered double hydroxide (LDH) supported Au catalysts for the targeted activation of the secondary O–H bond and provides deep insights into the active sites and the roles of the LDH support in glycerol selective oxidation. By virtue of the tailorable chemical composition of the LDH brucite-like layer, Zn2Fe-, Co2Al-, Zn2Al-, Zn2Ga-, and Mg2Al-LDHs, displaying varied surface basic densities and hydroxyl vacancies (VOH), were applied as supports for Au nanoparticles in this work. A glycerol conversion of 72.9 ± 0.2% and a dihydroxyacetone selectivity of 63.8 ± 0.2% were achieved on ZnGa-LDH-supported Au. In addition to Au0, surface Aun+ (Au+ and Au3+) species are abundant in the interfacial MII–O–Aun+ linkages. Detailed investigations verify the cooperation between the surface basic sites on the LDH support for the activation of the secondary O–H bonds and the interfacial MII–O–Au+ sites for the activation of the secondary C–H bonds. Significantly, on Zn-containing LDHs, an additional synergy exists between the surface VOH sites and the interfacial ZnII–O–Au3+ species to further promote catalytic activity.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acscatal.0c02844?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acscatal.0c02844</a>.Time course of product selectivity, high-resolution XPS spectra, catalytic performance in a fixed-bed trickle reactor, TEM images of the used catalyst, mass spectra, UV–vis diffraction spectra, the appendix of HPLC and GC, and the calibration curves for product identification and quantification (<a class="ext-link" href="/doi/suppl/10.1021/acscatal.0c02844/suppl_file/cs0c02844_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Stable and Active Au Catalyst Supported on CeMnO 3 Perovskite for Selective Oxidation of Glycerol

Stable and Active Au Catalyst Supported on CeMnO3 Perovskite for Selective Oxidation of Glycerol

Selective Oxidation of Glycerol in a Base-Free Aqueous Solution: A Short Review

Au‐Promoted Pt nanoparticles supported on MgO / SBA ‐15 as an efficient catalyst for selective oxidation of glycerol

Optimizing the Activity and Selectivity of Glycerol Oxidation over Core-Shell Electrocatalysts

Insights into the Multiple Synergies of Supports in the Selective Oxidation of Glycerol to Dihydroxyacetone: Layered Double Hydroxide Supported Au

Selective oxidation of glycerol over supported noble metal catalysts

PtAu alloying-modulated hydroxyl and substrate adsorption for glycerol electrooxidation to C3 products

Theoretical investigation on oxygen source for selective oxidation of glycerol at Au/CeO2− and Pt/CeO2− interfaces

Selective Glycerol Oxidation Using Platinum Nanoparticles Supported on Multi-Walled Carbon Nanotubes and Nitrogen-Doped Graphene Hybrid

Plant-mediated Biosynthesized Au/CuO Catalysts for Efficient Glycerol Oxidation to 1,3-Dihydroxyacetone: Effect of Biomass Component on Catalytic Activity

Mesoporous MnCeOx Solid Solutions for Low Temperature and Selective Oxidation of Hydrocarbons.

Sustainable Conversion of Glycerol into Value‐Added Chemicals by Selective Electro‐Oxidation on Pt‐Based Catalysts

Tailoring Facets of α-Mn 2 O 3 Microcrystalline Catalysts for Enhanced Selective Oxidation of Glycerol to Glycolic Acid

Oxidation of glycerol to dihydroxyacetone over highly stable Au catalysts supported on mineral-derived CuO-ZnO mixed oxide

Tuning the Product Selectivity Toward the High Yield of Glyceric Acid in Pt−CeO2/CNT Electrocatalyzed Oxidation of Glycerol

Electro-oxidation of Glycerol by Tetrametallic Platinum-Gold–palladium-silver Nanoparticles

Efficient and Stable Cu‐Cu2O@NC Catalysts for Selective Catalytic Conversion of Glycerol to Lactic Acid

Selective oxidation of glycerol to dihydroxyacetone over N-doped porous carbon stabilized CuxO supported Au catalysts

Base-free Aerobic Oxidation of Glycerol on TiO2-supported Bimetallic Au–Pt Catalysts

Engineering Pt-Mn2O3 interface to boost selective oxidation of ethylene glycol to glycolic acid