Abstract:With the rapid development of high-speed railway (HSR) in China, the problem of environmental vibration induced by HSR train has attracted critical concern. In this paper, a combination vibration reduction (CVR) strategy of hollow-closed-wall in-filled trench (HIT) and elastic bearing (EB) is proposed to decrease environmental vibration induced by HSR train, in which the depth of HIT could be well controlled to benefit the practical construction and economic cost. Based on the multi-body dynamics and finite element theory, HSR environmental vibration system is established and then divided into two sub-models including the 'train-track-bridge' vibration source sub-model and the 'pile-soil' vibration propagation sub-model. The two sub-models are connected via the force balance condition of the pier bottom. The verification of numerical models is conducted by comparing with the empirical formula and the ground data in the references. Then the attenuation law of environmental vibration is analyzed, and the vertical component is shown to be dominant in the HSR environmental vibration. On this basis, numerical simulations are performed to analyze the environmental vibration reduction under three strategies, namely the HIT, EB, and CVR. The results show that the HIT presents a distinct vibration reduction effect in the frequency range above 4 Hz and the vibration reduction becomes more obvious as the HIT's depth increases. However, the depth should be larger than 8 m to satisfy the code requirement; the EB presents an obvious reduction in the frequency range above 8 Hz; the CVR strategy not only further decrease the environmental vibration, but also effectively reduce the HIT's depth. By numerical analysis, the combination strategy of 6 m deep HIT and 2200 kN/mm vertical stiffness EB is recommended in the HSR environmental vibration reduction, which could also satisfy the limit of Chinese railway code.

Experimental research on vibration and noise of rail conveyor

Vibration and Noise Analysis and Experimental Study of Rail Conveyor

Characteristics and control of impact vibration and noise in rail belt conveyor

Investigation of Environmental Vibration Control for High Speed and Heavy Haul Railway

Experimental Study of Ground Vibration Caused by Rail Transit

Experimental Research on the Energy Consumption Laws and Its Influencing Factors of Belt Conveyor Systems

Experimental Investigation on the Vibration Reduction Characteristics of an Optimized Heavy-Haul Railway Low-Vibration Track

A Combination Strategy of Hollow-Closed-wall In-Filled Trench and Elastic Bearing for Reducing Environmental Vibration Induced by High-Speed Train

Experiment Investigation of Constrained Layer Damping Used for Vibration Suppression of Railway Wheel

Research on Noise Reduction Performance of Wheel–Rail with Amplitude Amplifying Vibration Absorber

Experimental noise and vibration characteristics of elevated urban rail transit considering the effect of track structures and noise barriers

Field measurement of rail corrugation influence on environmental noise and vibration: A case study in China

Dynamic Behaviour of a Conveyor Belt Considering Non-Uniform Bulk Material Distribution for Speed Control

Studies on Ground Environmental Vibration Induced by Urban Rail Transit

Ground vibration from freight railway: environmental impact and potential mitigation measure at propagation path

Regularities of particle motion on vibrating conveyor

Experimental Study on Viscoelastic Damping Materials for Noise Control in Railway Vehicles

Experimental Investigation on Noise Radiation Characteristics of an Urban Transit Train at Moderate and Low Speeds

Research on the Technology of the Wheel-rail Noise Reduction after Train Speed Increase

Evaluation of a rail-damper for the vibration reduction and noise suppress for railway

Study on Nonlinear Vibration of Vertical Lifting Section of Bulk Grain Entrainment Ship Unloader