Abstract:Among fuel cells, the direct methanol fuel cell (DMFC) has attracted great attention and has been considered a very promising power source because of the ease of methanol transportation and its high energy density. A major limiting factor hindering DMFC’s commercial application is the poor catalytic performance in the anode (methanol oxidation reaction). The methanol oxidation reaction (MOR) requires (OH-) from water dissociation as an oxygen donor for the reaction; however, the slow water dissociation on Pt limits the rate of MOR. In addition to the sluggish catalytic activity, the other major impediment for Pt catalysts is the generation of carbon monoxide (CO) during the MOR process.In order to improve the catalytic performance of MOR catalysts, a variety of catalyst design strategies have been devised. The interesting way of carrying out the MOR catalytic process is the non-CO pathway which takes place on Pt-Au bimetallic catalysts, thus eliminating CO poisoning. However, the overall activity of Pt-Au alloys in MOR is relatively low, which ultimately limits the application of Pt-Au catalysts. In this study, a nanoporous (np) Au-Cu-Pt thin-film catalyst with a fine structure and tunable composition is synthesized by using a facile method involving successive electrodeposition and de-alloying. SEM, SEM-EDX and ICP have been used for morphology characterization and composition assessment. Pb under-potential deposition (UPD), H UPD and CO stripping tests have been employed to determine the electrochemical active surface area (ECSA) and to probe the Pt active sites specifically. Also, cyclic voltammetry (CV) tests have been performed to assess the catalytic performance in MOR. Finally, long-term CV and chronoamperometry (constant potential) tests have been used to study and evaluate the durability of accordingly synthesized catalyst for MOR. The prepared np Au-Cu-(8% in the precursor alloy)Pt catalyst exhibits outstanding mass and specific activity toward the MOR, which is approximately six- and nine-times higher than the activity of a commercial Pt/C(40%) counterpart, respectively. A negative 75 mV onset potential shift upon the MOR anodic scan on the np Au-Cu-(8 %)Pt catalyst in comparison with Pt/C(40%) corroborates its higher catalytic activity. Furthermore, the alloy catalyst demonstrates better durability than the Pt/C(40%) counterpart in a three-hour constant potential test and exhibits full post-factum recovery of its cycling activity. In addition, it retains more than 60% of its original activity after 3000 cycles of an accelerated degradation test. Reference: Xie, Y., Li, C., Razek, S.A., Fang, J. and Dimitrov, N., 2020. Synthesis of Nanoporous Au− Cu− Pt Alloy as a Superior Catalyst for the Methanol Oxidation Reaction. ChemElectroChem, 7(2), pp.569-580.

Hierarchical PtCuMnP Nanoalloy for Efficient Hydrogen Evolution and Methanol Oxidation

Highly Active Nanoporous Pt-based Alloy As Anode and Cathode Catalyst for Direct Methanol Fuel Cells

Double Nanoporous Structure with Nanoporous PtFe Embedded in Graphene Nanopores: Highly Efficient Bifunctional Electrocatalysts for Hydrogen Evolution and Oxygen Reduction

Facile Synthesis of Ternary PtPdCu Alloy Hexapods As Highly Efficient Electrocatalysts for Methanol Oxidation

PdCu Alloy Nanodendrites with Tunable Composition As Highly Active Electrocatalysts for Methanol Oxidation

Facile Synthesis of Ptcu3 Alloy Hexapods and Hollow Nanoframes As Highly Active Electrocatalysts for Methanol Oxidation

Plasma-synthesized Octahedral PtPd Alloy/reduced Graphene Oxide Nanocomposites with Boosted Electrocatalytic Activity for Methanol Oxidation

Nanoporous Au-Cu-Pt As a Superior Electro-Catalyst for the Methanol Oxidation Reaction

Electroless Synthesis of Two-Dimensional Sandwich-Like Pt/Mn3O4/reduced-graphene-oxide Nanocomposites with Enhanced Electrochemical Performance for Methanol Oxidation

Multi-dimensional Pt/Ni(OH)2/nitrogen-doped Graphene Nanocomposites with Low Platinum Content for Methanol Oxidation Reaction with Highly Catalytic Performance

Fabrication of Bimetallic PtPd Alloy Nanospheres Supported on Rgo Sheets for Superior Methanol Electro-Oxidation

Au-doped PtCu 2 nanonetworks with interface-rich for enhancing methanol electro-oxidation performance

Highly Active and Durable Pt72ru28 Porous Nanoalloy Assembled with Sub-4.0 Nm Particles for Methanol Oxidation

Targeted Growth of Pt on 2D Atomic Layers of Ni-Al Hydroxide: Assembly of the Pt/Exfoliated Ni-Al Hydroxide Sheet/graphene Composite As Electrocatalysts for Methanol Oxidation Reactions

Enhancing Electrocatalytic Methanol Oxidation on PtCuNi Core–Shell Alloy Structures in Acid Electrolytes

Restructured PtNi on Ultrathin Nickel Hydroxide for Enhanced Performance in Hydrogen Evolution and Methanol Oxidation

Facile synthesis of trimetallic PtAuCu alloy nanowires as High−Performance electrocatalysts for methanol oxidation reaction

Alloyed Pt–Ru Nanoparticles Immobilized on Mesostructured Nitrogen-Doped Carbon Nanocages for Efficient Methanol Electrooxidation

Inducing ionic interaction in Pt 3 CuN nanocatalysts for superior stability and CO-resilient towards methanol oxidation

Mixed‐Dimensional Partial Dealloyed PtCuBi/C as High‐Performance Electrocatalysts for Methanol Oxidation with Enhanced CO Tolerance

The in Situ Etching Assisted Synthesis of Pt-Fe-Mn Ternary Alloys with High-Index Facets As Efficient Catalysts for Electro-Oxidation Reactions