On the Performance of Sentinel‐3 Altimetry Over New Reservoirs: Approaches to Determine Onboard A Priori Elevation

Xingxing Zhang,Liguang Jiang,Cécile M. M. Kittel,Zhijun Yao,Karina Nielsen,Zhaofei Liu,Rui Wang,Jun Liu,Ole B. Andersen,Peter Bauer‐Gottwein

DOI: https://doi.org/10.1029/2020gl088770

IF: 5.2

2020-08-25

Geophysical Research Letters

Abstract:Satellite radar altimetry has become an important data source supplementing in situ water level. For practical reasons, a radar altimeter can only record reflected echoes within its range window. Therefore, water surface elevation must fall within the range window. To this end, the Sentinel‐3 radar altimetry mission is configured with a new tracking function (i.e., open loop) to position its range window based on an onboard a priori elevation of ground targets. We found that Sentinel‐3 is unable to observe recently built reservoirs due to the incorrect onboard elevations. To overcome this issue, four approaches are proposed to improve the a priori elevation for inland water bodies, particularly reservoirs. These approaches can significantly increase data availability of Sentinel‐3 over reservoirs and can be used to prepare the onboard elevations of reservoirs and lakes for future missions such as Sentinel‐6, Sentinel‐3C/‐3D, and the Surface Water and Ocean Topography (SWOT) mission. Satellite radar altimetry is increasingly being used for hydrological studies. However, it is still challenging to deliver high‐quality data over inland water bodies, that is, lakes, rivers, and reservoirs. One of the reasons is that the altimeter cannot easily identify the water surface elevation due to highly variable terrain elevation along the satellite flight path. In other words, the data delivered may not contain valid information for water bodies. To address this issue, Sentinel‐3 is configured with a new function, which informs the altimeter about the expected elevation of the water surface. However, this function demands a priori knowledge of the altitude of the ground targets. We present four approaches to improve the a priori information to increase data availability over inland water bodies, specifically reservoirs. The Sentinel‐3A altimeter cannot deliver useful data over many reservoirs (constructed after 2005) in open‐loop tracking mode with OLTC V5 Defining correct a priori elevation information is the key to increasing data availability over reservoirs Four approaches are proposed to define the most accurate onboard a priori elevation

geosciences, multidisciplinary