Abstract:A method for speed and rotor position estimation of a brushless dc motor (BLDCM) is presented in this paper. An extended Kalman filter (EKF) is employed to estimate the motor state variables by only using measurements of the stator line voltages and currents. When applying the EKF, it was necessary to solve some specific problems related to the voltage and current waveforms of the BLDCM. During the estimation procedure, the voltage- and current-measuring signals are not filtered, which is otherwise usually done when applying similar methods. The voltage average value during the sampling interval is obtained by combining measurements and calculations, owing to the application of the predictive current controller which is based on the mathematical model of motor. Two variants of the estimation algorithm are considered: 1) speed and rotor position are estimated with constant motor parameters and 2) the stator resistance is estimated simultaneously with motor state variables. In order to verify the estimation results, the laboratory setup has been constructed using a motor with ratings of 1.5 kW, 2000 r/min, fed by an insulated gate bipolar transistor inverter. The speed and current controls, as well as the estimation algorithm, have been implemented by a digital signal processor (TMS320C50). The experimental results show that is possible to estimate the speed and rotor position of the BLDCM with sufficient accuracy in both steady-state and dynamic operation. Introducing the estimation of the stator resistance, the speed estimation accuracy is increased, particularly at low speeds. At the end of the paper, the characteristics of the sensorless drive are analyzed. A sensorless speed control system has been achieved with maximum steady-state error between reference and actual motor speed of ±1% at speeds above 5% of the rated value.

Sensorless control of induction motor drive using BEMF-MRAS with Kalman filter

Application of BEMF-MRAS with Kalman filter in sensorless control of induction motor drive

Adaptive Robust Sensorless Control for PMSM Based on Improved Back EMF Observer and Extended State Observer

Adaptive Sliding Mode Sensorless Vector Control of Induction Motor Using Sliding Mode MRAS Observer

Adaptive Sliding Mode Observer for Speed-Sensorless Control of PMSM

Sensorless IPMSM Control Based on an Extended Nonlinear Observer with Rotational Inertia Adjustment and Equivalent Flux Error Compensation

Sensorless Control Method Of Pmsm Based On Extended Kalman Filter

Backstepping Control of Speed for Sensorless Permanent Magnet Synchronous Motor

Second-Order Sliding-Mode Observer With Online Parameter Identification for Sensorless Induction Motor Drives

PMSM Mechanical Sensor-Less Vector Control Based on Extended Kalman Filter

Adaptive Observer for Sensorless Control of Permanent Magnet Synchronous Motor Drives

Sensorless Control of PMSM Based on Extended Kalman Filter

Sensorless Control for PMSM Drives Using the Cubature Kalman Filter based Speed and Flux Observer

Sensorless Control of Permanent Magnet Synchronous Motor Based on Extended Kalman Filter

Design and implementation of the extended Kalman filter for the speed and rotor position estimation of brushless DC motor

High Performance PMSM Sensorless Control with Load Torque Observation

Performance comparison of Rotor Flux based and Back EMF Based Model Reference Adaptive System Speed Estimator for 3 Phase Induction Motor

Sensorless Control of Permanent Magnet Synchronous Motor Based on Improved Model Reference Adaptive System

Permanent magnet synchronous motor sensorless control based on rotor flux observer with low-pass filter adaptation

High Performance PMSM Control System Based on Extended Kalman Filter

Improving Extended Kalman Filter for Speed Sensorless Vector Control of Induction Motor