OLED-Pumped Organic Laser Diode

Daan Lenstra,Alexis Fischer

DOI: https://doi.org/10.3390/photonics11040327

IF: 2.536

2024-04-02

Photonics

Abstract:A theoretical analysis is presented for a recently proposed high-speed μ-OLED optically pumped organic laser. We confirm that for this configuration, the laser threshold is reached at a lower current density than in the case of a direct-electrically pumped organic laser diode while generating pulses of order 15 ns duration. With a validated model for the electrically pumped organic light-emitting diode (OLED), we simulate the generation of light pulses. This light is fed into the organic laser section, where it optically pumps the emitting organic medium. The full model includes field-enhanced Langevin recombination in the OLED, Stoke-shifted reabsorption in both the OLED and organic laser, and an optical cavity in the latter. We numerically demonstrate 2 GHz modulation and conjecture the feasibility of ~0.025 Mb/s data transmission with this device.

optics

What problem does this paper attempt to address?

The problem that this paper attempts to solve is a series of challenges faced by organic laser diodes during direct electrical - injection pumping, especially the gain quenching problem caused by the accumulation of triplet excitons. Specifically:

1. **Gain quenching**: In directly electrically - injected pumped organic laser diodes, gain quenching is caused by bimolecular processes and light absorption due to polarons and triplets, thereby increasing the laser threshold.
2. **Stability and yield**: Even when using special active materials (such as BsB - Cz), the stability and yield of directly electrically - injected pumped organic laser diodes are still in question.
3. **High - speed modulation and data transmission**: Traditional organic laser diodes are difficult to achieve high - speed modulation and high data transmission rates.

To solve these problems, the author proposes a new method, that is, separating electrical injection and laser light generation in an integrated device. By using the electroluminescence generated by organic light - emitting diodes (OLEDs) to optically pump the organic laser medium, this method has the following advantages:

- **Reducing the laser threshold**: Optical pumping can significantly reduce the laser threshold because the laser gain in the organic medium will not be quenched by the excessively generated triplets.
- **Reducing light absorption**: The laser light is less absorbed by polarons and triplets, further reducing the laser threshold.
- **Efficient energy transfer**: By matching the refractive indices of the electroluminescence part and the active laser material part, the pump light can be efficiently transferred from the OLED to the laser part.

Through these improvements, the author has verified that the laser in this configuration can reach the laser threshold at a lower cavity Q - factor and can achieve a modulation frequency of 2 GHz, theoretically supporting a data transmission rate of about 0.025 Mb/s. However, due to the influence of triplet accumulation, continuous - wave (CW) emission and gigabit - data - transmission are still difficult to achieve.