Effect of electrical parameters and slag system on macrostructure of electroslag ingot

Shi, Xiao-fang

DOI: https://doi.org/10.1007/s41230-024-3064-3

2024-01-11

China Foundry

Abstract:To investigate the influence of electric parameters and slag system on the solidification quality of electroslag ingot during electroslag remelting, different power supply modes, current strengths and remelting slag systems were used to conduct electroslag remelting experiments on 304L austenitic stainless steel, and the macrostructure of electroslag ingots was analyzed. The results indicate that the depth of the metal pool decreases with the reduction of remelting frequency in the low frequency power supply mode. The effects of different power supply modes, such as low-frequency, direct current straight polarity (DCSP), and direct current reverse polarity (DCRP), on reducing the depth of the metal pool increase in that order. By reducing the remelting current strength in the same power supply mode, the depth of metal pool is reduced. When compared to the binary slag system of 70% CaF 2 +30% Al 2 O 3 , the ternary slag system of 60% CaF 2 +20% Al 2 O 3 +20% CaO is more effective in reducing the depth of the metal pool during remelting. Utilizing the 60% CaF 2 +20% Al 2 O 3 +20% CaO ternary slag system results in a shallower and flatter metal pool, with columnar crystal growth occurring closer to the axial crystal. This effect is observed for both low frequency and direct current (DC) power supply modes.

metallurgy & metallurgical engineering

What problem does this paper attempt to address?

The paper mainly explores the effects of electrical parameters (such as power supply frequency and current intensity) and slag systems on the macrostructure of electroslag ingots during the electroslag remelting process. Specifically:

1. **Effects under different power supply modes**: The study found that under low-frequency power supply modes, as the frequency decreases (from 10 Hz to 5 Hz to 2 Hz), the depth of the metal pool gradually decreases, and columnar crystals tend to grow along the axial direction. Compared to low-frequency power supply modes, the metal pool produced by direct current (DC) power supply modes (especially reverse polarity DC) is shallower.

2. **Effects of different current intensities**: Under low-frequency power supply modes or DC power supply modes, reducing the remelting current intensity can further reduce the angle between the temperature gradient direction and the axial direction, making the metal pool shallower and correspondingly increasing the equiaxed crystal zone.

3. **Effects of different slag systems**: Compared to the binary slag system (30% Al2O3 + 70% CaF2), the ternary slag system (20% Al2O3 + 20% CaO + 60% CaF2) can produce flatter columnar crystals that grow closer to the axial direction, resulting in a shallower metal pool.

In summary, by adjusting the power supply frequency, current intensity, and adopting different slag systems, the solidification quality during the electroslag remelting process can be effectively improved.