Abstract:In this study, a cost-effective high-fidelity six-degree of freedom module augmented with an onboard controller is developed. The unmanned aerial vehicle (UAV) under consideration is a wing-alone configuration with a cropped delta planform and reflex airfoil cross-section designed to perform manoeuvres at high angles of attack. The six-degree of freedom dynamics for the aforementioned configuration is developed based on Newtonian mechanics incorporating linear and nonlinear aerodynamic models to expand flight simulations in corresponding regimes. Aerodynamic stability and control parameters for the simulations are obtained from full-scale wind tunnel measurements and flight tests. It is observed that the linear aerodynamic model is valid in angle of attack ( α ) domain −5°≤α≤10° , followed by nonlinearity up to α≈21° , post which lift coefficient remains almost constant with angle of attack till 45°. The simulation model is validated with the corresponding flight data obtained from flight tests. A user-friendly graphical interface with real-time animation of UAV has been developed for the aforementioned configuration by integrating MATLAB and Flightgear environment with real-time control input from the hardware to enable the pilot for visual and tactile feedback, respectively. A controller based on total energy control is designed for velocity and altitude hold modes, while an attitude hold controller is designed for pitch and roll angle tracking to enable controller-in-the-loop remote piloting simulations. In order to enhance practical applicability, the designed module has been tested under various simulated wind conditions. It is noticed from the results that the steady-state error in attitude remains below 2% with a maximum overshoot of 5° from reference. The total energy controller achieves a zero steady-state error with a maximum overshoot of 2 m/s for velocity and 6 m for altitude, respectively. The developed module enhances remote piloting training, flight response assessment, and control algorithm testing for cropped delta planform UAVs.

Unified controller for take-off and landing for a fixed-wing aircraft

A full controller for a fixed-wing UAV

Design of Thrust Vectoring Vertical/Short Takeoff and Landing Aircraft Stability Augmentation Controller Based on L1 Adaptive Control Law

Design of a Smooth Landing Trajectory Tracking System for a Fixed-wing Aircraft

Unified incremental nonlinear controller for the transition control of a hybrid dual-axis tilting rotor quad-plane

Unified Control of Flight Dynamics and Actuators Using Local Accelerations

Modeling and Passivity-Based Control for a convertible fixed-wing VTOL

Automatic landing system design via multivariable model reference adaptive control

Guiding Lunar Landers: Harnessing Neural Networks for Dynamic Flight Control with Adaptive Inertia and Mass Characteristics

Controller design and remote piloting training module development for unmanned cropped delta reflex wing configuration

Nonlinear control of a planar vertical take‐off and landing with a slung load

Modeling and Control of an Aerial Flight Platform Using for Fixed-Wing UAV Landing.

Multimodal Dynamics Analysis and Control for Amphibious Fly-Drive Vehicle

The Soft-PVTOL: modeling and control

Robust Stabilized Control for Electric Vertical Take-Off and Landing (eVTOL) Fixed-Wing Aircraft

Modeling and Design of an Aircraft-Mode Controller for a Fixed-Wing VTOL UAV

Flight Test of L 1 Adaptive Control on 120-kg-Class Electric Vertical Take-Off and Landing Vehicles

Integrated translational and rotational control for the terminal landing phase of a lunar module

An Aerodynamic Feedforward-Feedback Architecture for Tailsitter Control in Hybrid Flight Regimes

Attitude- and Cruise Control of a VTOL Tiltwing UAV

Modeling and control of a class of urban air mobility tiltrotor aircraft