Systematic Approach to the Design and Application of a Weighted Fracturing Fluid To Ensure Deepwater Production
Karen Elaine Olson,Edward Irving Park,Benjamin J. Weber,Kay E. Cawiezel,Terry D. Monroe,Carolyn S. De Vine,Jennifer Cutler,Sandra Lee Berry
DOI: https://doi.org/10.2118/103089-ms
2006-09-24
Abstract:Abstract As deepwater exploration projects in the Gulf of Mexico and other offshore areas have gained momentum, development activities in all areas of drilling, completion and production of these wells have faced significant challenges. One key area of concern in completion of these wells is the design, application and compatibility of the fracturing fluid to ensure optimum well performance. Deepwater engineering design and application of fracturing fluids are presented with some unique challenges in well depths that can exceed 20,000 ft with pore pressures greater than 20,000 psi. One major issue facing deepwater fracturing is generating enough bottomhole treating pressure to create a hydraulic fracture at the sandface without exceeding the limitations of the hydraulic equipment at the surface. In order to overcome these surface hydraulic equipment limitations and still create the needed hydraulic fracturing pressure at thesandface, weighted fracturing fluid formulations have been developed to address these issues. Furthermore, due to the increased travel distance to the sandface and the extreme temperature ranges that the fluid is exposed from the mudline to the BHT, the fracturing fluid must have flexibility to be designed to meet specific density, extended crosslink delay times, friction pressures, and compatibility specifications. This paper summarizes a study to formulate a sodium bromide weighted, delayed crosslink fracturing fluid system to meet the fluid and engineering guidelines for the fracturing application. After baseline fluid formulation studies with theweighted sodium bromide, delayed crosslink fracturing fluid system were designed, rheological performance with breakers at BHT were run, stacked cell regained conductivity lab measurements were performed and friction pressures were determined. Additional studies were also conducted with this weighted fracturing fluid to determine compatibility with the well's produced crude oil and returned permeability studies utilizing formation cores. Introduction Oil and gas exploration projects in the deepwater areas of the Gulf of Mexico and other offshore locations have steadily increased in the last decade due to large abundance of reserves in these formations. However, along with the economic rewards of producing these giant fields, comes a set of as difficult operational demands that are equal to or greater than the challenge to recover them. Development activities in all areas of drilling, completion, and production of these wells have faced significant challenges due to the combination of high bottomhole pressures and temperatures. In order to reduce the uncertainties in these areas, experienced teams of key personnel were formed in their expertise areas to address development of new systems and to enhance pre-planning activities, risk management, and quality control procedures in all areas of the completion processes. One key area of concern in the completion of these deepwater wells is the design, application, and compatibility of the fracturing fluid to obtain maximum well production. Deepwater engineering design and application of fracturing fluids face unique challenges in well depths exceeding 20,000 feet with pore pressures greater than 20,000 psi. One of the major issues facing deepwater fracturing is generation of enough bottomhole treating pressure to create a hydraulic fracture at the sandface without exceeding the limitations of the hydraulic equipment at the surface. In order to overcome these surface hydraulic equipment limitations and still create the required hydraulic fracturing pressure at the sandface, weighted fracturing fluid formulations have been developed to address these issues. Furthermore, due to the increased travel distance to the sandface and the extreme temperature ranges that the fluid is exposed from the mudline to the BHT, the fracturing fluid must have flexibility to be designed to meet specific density, extended crosslink delay times, friction pressures, and compatibility specifications.