Abstract:The massive integration of renewable energy sources and power electronics into the power grid leads to the strong need of real-time Electromagnetic Transients (EMT) simulation of power system using field-programmable gate array (FPGA) platform due to its high efficiency and superior performance. FPGA based EMT simulations A key for Digital Twin were mainly based on Single-Precision calculations, but ignored potential accumulation displacement. To address this problem, this paper proposes full Double-Precision and Mixed-Precision Floating-Point schemes to achieve optimal balance between numerical accuracy and computational resource cost in FPGA-based EMT simulation even for long duration simulations. Furthermore, adjustable pipeline, address dynamic access and sequence controller techniques for solving high fanout and long datapath hardware implementation are developed to optimize resource usage and timing constraints for all schemes. For non-rotating components, full Double-Precision and full Single-Precision both shows excellent convergence. For rotating components, extra Single-Precision iteration method and Mixed-Precision calculations are compared for Synchronous Machines (SG) with strong nonlinearity, and it is found that only full Double-Precision could avoid phase shift problem. Based on component-level sensitivity analysis, proposed system-level Mixed-Precision scheme is able to achieve close accuracy to that of full Double-Precision scheme and additional average 20 resource reduction for Kundur's system.

Optimized Real-Time Stochastic Model of Power Electronic Converters based on FPGA

Design of High Accuracy High Conversion Ratio Single-Stage Switching Power Converter for Modern FPGAs at 10Mhz

Modeling and Analysis of PWM Converters with a New GSSA Method

Uncertainty Analysis of Power System Time-Domain Simulation Based on Generalized Polynomial Chaos Method

A Universal Model for Grid-Connected Converters Reflecting Power-Internal Voltage Characteristics

Fuzzy Approximation ARX Model-based Intelligent Two-Horizon Robust FCS-MPC for Power Converter

Modeling Method for the Real-Time Simulation of Bridge-Based High-Switching-Frequency Power Electronic Converters

Real-Time Simulation of Power Electronic Systems Based on Predictive Behavior

Real-Time Simulation of Power System Electromagnetic Transients on FPGA Using Adaptive Mixed-Precision Calculations

A Fuzzy Approximation for FCS-MPC in Power Converters

Reinforcement Learning-Based Event-Triggered FCS-MPC for Power Converters

Efficient Prototyping of a Field-Programmable Gate Array-Based Real-Time Model of a Modular Multilevel Converter

Rapid Modeling and Simulation Method for Inverter-interfaced Distributed Generators

Event-Triggered ESO-Based Robust MPC for Power Converters

State-Space Modeling of Grid-Connected Power Converters Considering Power-Internal Voltage Characteristics

Virtual Voltage Vector-Based Sequential Model-Free Predictive Control for Multiparalleled NPC Inverters

Low Cost and Optimized FPGA-HIL Real Time Simulation of a Boost Converter Powered by a Photovoltaic Panel

Topology-Aware Matrix Partitioning Method for FPGA Real-Time Simulation of Power Electronics Systems

An Extended Impedance Model for Power Electronics Converters Retaining Explicit Synchronization Dynamics

A Coupled 3D FEM-Distribute Circuit Model for Numerical Analysis of Small Time Scale Transients of an IGBT based Inverter

On Modeling Depths of Power Electronic Circuits for Real-Time Simulation – A Comparative Analysis for Power Systems