Abstract:According to the operation parameters and the design experience parameters, a liquid hydrogen centrifugal pump was developed and tested to meet an application requirement of small flow and high head in cryogenic systems or cryogenic storage tanks. The test results showed that 6 m of hydraulic loss in the pump at the rated condition and the inlet pressure of the cryogenic fluid decreased and fluctuated, which resulted in the pump being prone to cavitation . To improve cavitation resistance and hydraulic efficiency of liquid hydrogen centrifugal pumps, the model was optimized based on the genetic algorithm of MATLAB applying 7 parameters of impeller taken as optimization variables, each sub-objective function was given corresponding weights, and the optimal solution combination at the minimum of the objective function was finally obtained, and an inducer was matched. The results showed that by reducing the angle of the inlet, increasing the diameter of the impeller, and adding an inducer, the cavitation performance of the pump can be improved and the hydraulic loss can be reduced by appropriately reducing the impeller outlet diameter, to improve the head of the pump. A comparison of the performance of the preposition inducer optimized pump with the preliminary pump shows that, at the rated condition point, the head was increased by 4.6 m resulting in an efficiency of 43%. A numerical calculation considered the thermodynamic effect of non-isothermal cryogenic cavitation on the Reynolds-averaged Navier-Stokes combined with the k - ε turbulence model was applied for getting the pump hydrodynamic performances. It was proved that the multi-objective optimization method and preposition inducers were effective, and the calculating results were by experimental data well. Feasibility of the model had been validated to a certain extent. It can bring a high level of pump optimization, integration, and quality to new and existing designs.

Influence of cavitation on inducer and return channels of LNG pump

Rotating Cavitation of the High-Speed Rotational Inducer of LPRE

Research on Cavitation Characteristic of Inducer

Investigation on Cryogenic Cavitation Characteristics of an Inducer Considering Thermodynamic Effects

Numerical and experimental analysis of the cavitation and flow characteristics in liquid nitrogen submersible pump

Study of the Flow in a Cryogenic Pump under Different Cavitation Inducements by Considering the Thermodynamic Effect

Investigation of the cavitation model in an inducer for water and liquid nitrogen

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Numerical Simulation of the Cavitation Characteristics of A Mixed-Flow Pump

Liquid hydrogen centrifugal pump optimization based on reducing hydraulic loss and improving cavitation

Analysis of internal flow and energy loss in a LNG cryogenic submerged pump

Experimental and numerical investigations of cavitation evolution in a high-speed centrifugal pump with inducer

Dynamic Behaviors of Blade Cavitation in a Water Jet Pump with Inlet Guide Vanes: Effects of Inflow Non-Uniformity and Unsteadiness

Numerical investigation of cavitating flows in bulb tubular pump and its performance prediction

Research on Visualization of Inducer Cavitation of High-Speed Centrifugal Pump in Low Flow Conditions

Influence of impeller-tongue interaction on the unsteady cavitation behavior in a centrifugal pump

Liquid-vapor two-phase flow in centrifugal pump: Cavitation, mass transfer, and impeller structure optimization

Visual experiment and numerical simulation of cavitation instability in a high-speed inducer

Impact of Double-Suction Pump Eye Diameter Variation on Cavitation Phenomena

Numerical Research on the Cavitation Characteristics for Typical Conditions of A Centrifugal Pump with Whole Flow Passage

Numerical study on the cavitation phenomenon for the head drop and unsteady bubble patterns with a difference in the incidence angle of a mixed-flow pump