Abstract:On 24 March 2021, an Mw 5.3 earthquake struck northwest Baicheng, located in the Kuqa fold‐and‐thrust belt (FTB), northwest China. In the current study, interferometric synthetic aperture radar (InSAR) data were used to investigate the associated fault rupture solution (dip, dip direction, and slip sense), to determine the geometry of the seismogenic structure; the high‐resolution images of the surface rupture were obtained using an unmanned aerial vehicle (UAV). This geometric model, along with the co‐seismic slip distribution from the InSAR data, and deformation characteristics of co‐seismic surface rupture revealed that: (a) it was a shallow event, the focal depth was 0.5–2 km, and the co‐seismic slip was distributed in the 0–7 km range with high dip angles (66°, 70°). (b) A 4‐km long surface rupture with obvious left‐lateral strike‐slip was distributed on the surface, and the maximum strike‐slip displacement and width were 0.79 and 0.7 m, respectively. This left‐lateral strike‐slip event indicates that the relative motion between the Tianshan and Tarim blocks is a continuous and diffuse deformation process. The study shows that, when evaluating the earthquake risk of the Kuqa FTB, we should consider both the front position of the fault outburst and the internal compressional salt‐related structures, which can also produce moderate to strong earthquakes. The northwest of Baicheng, Xinjiang was struck by an Mw 5.3 earthquake on 24 March 2021, representing the largest event in the Kuqa fold‐and‐thrust belt in the past 20 years. This event has several intriguing aspects (a) the surface rupture and epicenter (U.S. Geological Survey and China Earthquake Networks Center): did not occur on a mapped fault; (b) the focal depth was 0.5–2 km, characteristic of a shallow earthquake; (c) the seismic rupture characteristics were incongruous with regional strain. Based upon an integrative analysis for interferometric synthetic aperture radar and unmanned aerial vehicle data, we obtained the deformation field, co‐seismic slip distribution, and surface rupture. The deformation field was found to be 16.5 km long and 7.7 km wide, while the surface rupture length was 4 km and exhibited characteristics of left‐lateral strike‐slip deformation. We found an isolated and shallow compressional salt dome below the epicenter, which corresponds well with the rupture characteristics of the source. It is, therefore, believed that the earthquake was caused by rupture of the compressed salt structure. Our study has important implications for understanding the relative geohazard and movement characteristics of the Tarim and Tianshan blocks. The 2021 Mw 5.3 Baicheng earthquake may have involved at least 4 km of surface rupture The earthquake may have ruptured with three segments, involving both left‐lateral strike‐slip and tensional fractures The earthquake was a shallow (focal depth 0.5–2 km) left‐lateral strike‐slip (maximum displacement: 0.79 m) rupture event The 2021 Mw 5.3 Baicheng earthquake may have involved at least 4 km of surface rupture The earthquake may have ruptured with three segments, involving both left‐lateral strike‐slip and tensional fractures The earthquake was a shallow (focal depth 0.5–2 km) left‐lateral strike‐slip (maximum displacement: 0.79 m) rupture event

Rupture Process of the 2017 Mw 6.3 Earthquake in Jinghe, Northwest China, Constrained by GNSS, InSAR, and Teleseismic Waveforms

Resolving the Rupture Directivity and Seismogenic Structure of the 2017 Jinghe Ms6. 6 Earthquake with Regional Seismic Waveforms

Rupture Process of the 2021 M7.4 Maduo Earthquake and Implication for Deformation Mode of the Songpan-Ganzi Terrane in Tibetan Plateau

Lower Portion Rupture of a Thrust Fault During the 2017 Mw 6.3 Jinghe Earthquake: Implications to Seismic Hazards in the Tian Shan Region

Rupture Branching, Propagation, and Termination at the Eastern End of the 2021 Mw 7.4 Maduo Earthquake, Northern Tibetan Plateau

Limit on Slip Rate and Timing of Recent Seismic Ground-Ruptures on the Jinghong Fault, SE of the Eastern Himalayan Syntaxis

Multiple Mw≥6.5 Strong-Major Paleoearthquakes Occurred Before the 2017 Mw 6.3 Jinghe Earthquake: Evidence from Trenching the Jinghenan Fault

Coseismic Surface Deformation and Source Mechanism of the 2023 Ms 6.2 Jishishan Earthquake, Northeastern Tibetan Plateau

Fault model of the 2017 Jiuzhaigou Mw 6.5 earthquake estimated from coseismic deformation observed using Global Positioning System and Interferometric Synthetic Aperture Radar data

InSAR coseismic deformation field and seismogenic structure of the 2020 Mw6.0 Jiashi earthquake and the implication for the moderate-magnitude seismicity in the southwestern Tian Shan, western China

Rupture Process and Aftershock Focal Mechanisms of the 2022 M6.8 Luding Earthquake in Sichuan

Asymmetric Bilateral Rupture of the 2022 Ms 6.8 Luding Earthquake on a Continental Transform Fault, Tibetan Border, China

Tectonic Deformation Study of Nov.25, 2016 Mw 6.6 Earthquake in West Kunlun Mountain Based on InSAR Technology

Coseismic Deformation and Fault Inversion of the 2017 Jiuzhaigou Ms 7.0 Earthquake: Constraints from Steerable Pyramid and InSAR Observations

The 2017 Jiuzhaigou Earthquake: A Complicated Event Occurred in a Young Fault System

A hybrid source mechanism of the 2017 Mw 6.5 Jiuzhaigou earthquake revealed by the joint inversion of strong-motion, teleseismic and InSAR data

The 2020 M-w 6.0 Jiashi Earthquake: Coinvolvement of Thin-Skinned Thrusting and Basement Shortening in Shaping the Keping-Tage Fold-and-Thrust Belt in Southwestern Tian Shan

Joint Inversion of Rupture Across a Fault Stepover During the 8 August 2017 Mw 6.5 Jiuzhaigou, China, Earthquake

Co-seismic thrusting rupture and slip distribution produced by the 2008 Mw 7.9 Wenchuan earthquake, China

The 2021 M W 7.4 Madoi Earthquake: an Archetype Bilateral Slip‐pulse Rupture Arrested at a Splay Fault

A Shallow and Left‐Lateral Rupture Event of the 2021 Mw 5.3 Baicheng Earthquake: Implications for the Diffuse Deformation of Southern Tianshan