Abstract:The migration of grain boundaries leads to grain growth in polycrystals and is one mechanism of grain-boundary-mediated plasticity, especially in nanocrystalline metals. This migration is due to the movement of dislocationlike defects, called disconnections, which couple to externally applied shear stresses. While this has been studied in detail in recent years, the active disconnection mode was typically associated with specific macroscopic grain boundary parameters. We know, however, that varying microscopic degrees of freedom can lead to different atomic structures without changing the macroscopic parameters. These structures can transition into each other and are called complexions. Here, we investigate [111 ̄] symmetric tilt boundaries in fcc metals, where two complexions—dubbed domino and pearl—were observed before. We compare these two complexions for two different misorientations: In Σ19b[111 ̄](178) boundaries, both complexions exhibit the same disconnection mode. The critical stress for nucleation and propagation of disconnections is nevertheless different for domino and pearl. At low temperatures, the Peierls-like barrier for disconnection propagation dominates, while at higher temperatures the nucleation is the limiting factor. For Σ7[111 ̄](145) boundaries, we observed a larger difference. The domino and pearl complexions migrate in different directions under the same boundary conditions. While both migration directions are possible crystallographically, an analysis of the complexions' structural motifs and the disconnection core structures reveals that the choice of disconnection mode and therefore migration direction is directly due to the atomic structure of the grain boundary. https://doi.org/10.1103/PhysRevMaterials.8.063602 Published by the American Physical Society under the terms of the Creative Commons Attribution 4.0 International license. Further distribution of this work must maintain attribution to the author(s) and the published article's title, journal citation, and DOI. Open access publication funded by Max Planck Society. Published by the American Physical Society

Linear complexions directly modify dislocation motion in face-centered cubic alloys

Prediction of a wide variety of linear complexions in face centered cubic alloys

Strengthening from dislocation restructuring and local climb at platelet linear complexions in Al-Cu alloys

Dislocation breakaway from nanoparticle array linear complexions: Plasticity mechanisms and strength scaling laws

Interdependent linear complexion structure and dislocation mechanics in Fe-Ni

Dislocation-assisted linear complexion formation driven by segregation

Grain boundary complexions and the strength of nanocrystalline metals: Dislocation emission and propagation

Effect of the atomic structure of complexions on the active disconnection mode during shear-coupled grain boundary motion

Effect of amorphous complexions on plastic deformation of nanolayered composites

Understanding Orientation-Dependent Plasticity in Laser Beam Powder Bed Fusion Stainless Steel Through Crystal Plasticity Modelling

Ultra-high Strength and Plasticity Mediated by Partial Dislocations and Defect Networks: Part I: Texture Effect

Amorphous complexions alter the tensile failure of nanocrystalline Cu-Zr alloys

Composition-dependent slip planarity in mechanically-stable face centered cubic complex concentrated alloys and its mechanical effects

Enhanced mobility of dislocation network nodes and its effect on dislocation multiplication and strain hardening

Local structural ordering determines the mechanical damage tolerance of amorphous grain boundary complexions

Topology and Evolution of Dislocation Structures Mediated by Glissile Reactions in Face-Centered Cubic Metals

Elastic Interaction-Induced Anisotropic Growth of Dislocation Loop Arrays

Interface Dislocation Patterns and Dislocation Nucleation in Face-Centered-cubic and Body-Centered-cubic Bicrystal Interfaces

Fluctuations in local shear-fault energy produce unique and dominating strengthening in metastable complex concentrated alloys.