Abstract:Chemical dyes used in the textile industries are one of the major pollutants in water. Methylene blue (MB) is a commonly seen dye that creates hazardous health problems. In this article the photocatalytic degradation of MB by the nanocatalyst MoS 2 (Nano-MoS 2 ) and carbon dot (C Dots) incorporated MoS 2 (Nano-CD-MoS 2 ) is reported. The photocatalytic degradation of MB is analyzed based on the electron-hole recombination rate of the catalyst. Photoluminescence emission exhibited by the catalyst is used as a key indicator to probe the electron-hole recombination rate. Nano-MoS 2 was synthesized hydrothermally at 180 0 C for 8 h from ammonium tetra thiomolybdate (ATTM). C Dot was prepared following a green root from ash guard extract which later mixed with Nano-MoS 2 and kept in an autoclave at a temperature 140 °C for 4 h to get Nano-CD-MoS 2 . The photoluminescence (PL) and photocatalytic behavior of Nano-MoS 2 and Nano-CD-MoS 2 and their application for water splitting and water purification are reported. The incorporation of graphene and artificial C Dot into MoS 2 nanostructures are reported to increase the conductivity and active edge sites of MoS 2 that enhances the photocatalytic action. Since green C Dots are eco-friendly and easily synthesizable than artificial C Dots, as a novel study, this article investigated the influence of green C Dots on the PL and photocatalytic performance of nanosized MoS 2 . Nano-MoS 2 and Nano-CD-MoS 2 exhibited both upconversion and downconversion PL; accordingly the nanostructures were termed as amphi -luminescent. The amphi -luminescence property widens the photon absorption range and hence enhances the catalytic degradation of dyes. Nano-MoS 2 which exhibited lesser intensity of amphi -luminescence emission compared to Nano-CD-MoS 2 showed better results in degradation of MB. C Dots may bind with the valence band electrons of MoS 2 , resulting in the reduction of dangling bonds Dangling bonds can trap photo-induced excitons to hinder the rate of electron-hole recombination. So, fast electron-hole recombination occurs in Nano-CD-MoS 2 than Nano-MoS 2 . Fast electron-hole recombination supports radiative electron-hole recombination while suppresses the non-radiative energy transfer of electrons and causes high PL intensity. However, according to the energy level diagram, Nano-MoS 2 with minimal electron-hole recombination rate is more favorable for O 2 /O 2 – ,OH/ OH – andOH/H 2 O reactions that facilitate MB degradation. Photocatalytic activity of catalysts were confirmed by measuring the photocurrent from a simple custom-made two-electrode water photolysis cell where the nanocatalysts were dispersed in electrolyte. Lead and steel rods were used as electrodes. Multimeter was used to measure current. Nano-MoS 2 exhibited better performance with a maximum photocurrent of 141 μA. Influence of green C Dots in energy levels, PL and photocatalysis of MoS 2 and mechanisms of PL and degradation of MB are thoroughly investigated in this article.

S,Cl-doped-C-dots and S-g-C3N4 heterojunction for enhanced photocatalytic remediation of dye-polluted wastewater

Accelerated Decoloration of Organic Dyes from Wastewater Using Ternary Metal/g-C3N4/ZnO Nanocomposites: An Investigation of Impact of g-C3N4 Concentration and Ni and Mn Doping

Graphitic Carbon Nitride Facilely Modified with Pyromellitic Diimide with Enhanced Photocatalytic Activity and Good Selectivity Towards the Photodegradation of Cationic Dyes

Fabrication of g-C 3 N 4 /CuS heterojunction: A potential Z scheme photocatalyst for dye degradation in aqueous media under direct sunlight illumination

Preparation Of Bi2s3/Carbon Quantum Dot Hybrid Materials With Enhanced Photocatalytic Properties Under Ultraviolet-, Visible- And Near Infrared-Irradiation

Synergistic photocatalytic performance of MoO 3 :Cu/g-C 3 N 4 heterojunction semiconductor for efficient crystal violet dye degradation: A sustainable approach for environmental remediation

Construction of N-doped g-C3N4/NH2-MIL-125(Ti) S-scheme heterojunction for enhanced photocatalytic degradation of organic pollutants: DFT calculation and mechanism study

A novel carbon doped CeO 2 /g-C 3 N 4 heterostructure for disinfection of microorganisms and degradation of Malachite green and Amoxicillin under sunlight

Facile Synthesis of “Boron-Doped” Carbon Dots and Their Application in Visible-Light-Driven Photocatalytic Degradation of Organic Dyes

Enhanced Photocatalytic Degradation of Cr (VI) and Organic Pollutants Using Novel 3D/2D MoS 2 /SnS 2 Heterostructures for Water Remediation

Ligand modulated charge transfers in Z-scheme configured Ni-MOF/g-C3N4 nanocomposites for photocatalytic remediation of dye-polluted water

Amphi-Luminescent MoS 2 nanostructure for photocatalytic splitting of water and removal of Methylene Blue

ZIF-8 incorporated CeO2-CdS quantum dots @ 2D g-C3N4 nanosheets as a staggered type II heterojunction for decolouration of a set of dyes

Development of a MOF-5/g-C3N4 nanocomposite: an effective type 2 heterojunction photocatalyst for rhodamine B dye degradation

Boosting Degradation of Synthetic Dye and Pesticide Residues in Water Using NCDs/FeNH2BDC Photocatalysts

Development of 2D/2D h-MoO 3 /Ag/g-C 3 N 4 heterojunction photocatalyst with enhanced photocatalytic performance for the detoxification of methylene blue and tetracycline under solar light illumination

A dual S-scheme g-C3N4/Fe3O4/Bi2WO6/Bi2S3 heterojunction for improved photocatalytic decomposition of methylene blue: Proposed mechanism, and stability studies

Hybrid multifunctional core/shell g-C3N4@TiO2 heterojunction nano-catalytic for photodegradation of organic dye and pharmaceutical compounds

Comprehensive removal of various dyes by thiourea modified chitosan/nano ZnS composite via enhanced photocatalysis: Performance and mechanism

Visible-Light-Induced Photocatalytic Degradation of Rhodamine B Dye Using a CuS/ZnS p-n Heterojunction Nanocomposite under Visible-Light Irradiation

Constructing 3D flower-like S-scheme N-Bi2O2CO3/g-C3N4 heterojunction with enhanced photocatalytic performance