Abstract:We have studied the impact of dissolved aluminum on interfacial properties of two aluminum bearing minerals, corundum and kaolinite. The effect of intentionally adding dissolved aluminum on electrokinetic potential of basal plane surfaces of sapphire was studied by streaming potential measurements as a function of pH and was complemented by a second harmonic generation (SHG) study at pH 6. The electrokinetic data show a similar trend as the SHG data, suggesting that the SHG electric field correlates to zeta-potential. A comparable study was carried out on kaolinite particles. In this case electrophoretic mobility was measured as a function of pH. In both systems the addition of dissolved aluminum caused significant changes in the charging behavior. The isoelectric point consistently shifted to higher pH values, the extent of the shift depending on the amount of aluminum present or added. The experimental results imply that published isoelectric points of clay minerals may have been affected by this phenomenon. The presence of dissolved aluminum in experimental studies may be caused by particular pre-treatment methods (such as washing in acids and subsequent adsorption of dissolved aluminum) or even simply by starting a series of measurements from extreme pH (causing dissolution), and subsequently varying the pH in the very same batch. This results in interactions of dissolved aluminum with the target surface.A possible interpretation of the experimental results could be that at low aluminum concentrations adatoms of aluminum (we will refer to adsorbed mineral constituents as adatoms) can form at the sapphire basal plane, which can be rather easily removed. Simultaneously, once the surface has been exposed to sufficiently high aluminum concentration, a visible change of the surface is seen by AFM which is attributed to a surface precipitate that cannot be removed under the conditions employed in the current study.In conclusion, whenever pre-treatment or the starting point of an experiment favor the dissolution of aluminum, dissolved Al may remain in the experimental system and interact with the target surfaces. The systems are then no longer pristine and points of zero charge or sorption data are those of aluminum-bearing systems.

Electrochemical Properties of Na–Attapulgite

A Molecular Dynamics Study on the Structural and Mechanical Properties of Pyrophyllite and M-Montmorillonites (M = Na, K, Ca, and Ba)

Characterization of the surface charge distribution on kaolinite particles using high resolution atomic force microscopy

Attapulgite: Properties and Uses

Quantifying Specific Ion Effects on the Surface Potential and Charge Density at Silica Nanoparticle–Aqueous Electrolyte Interfaces

Effects of Different Treatments on the Structure and Characteristic of Attapulgite Clay

Adsorption of Metal Ions at Kaolinite Surfaces: Ion-specific Effects, and Impacts of Charge Source and Hydroxide Formation

Adsorption of dissolved aluminum on sapphire-c and kaolinite: implications for points of zero charge of clay minerals

Molecular-level insights into pH regulation of cation adsorption and exchange at clay particle edges

Preferential Adsorption in Mixed Electrolytes Confined by Charged Amorphous Silica

Investigation of the Method for Measuring the Surface Property Parameters of Variable Charge Minerals Using Ion Selection Electrode

Investigation of the surface charge behaviour of ettringite: Influence of pH, calcium, and sulphate ions

Competitive Adsorption of Metal Ions at Smectite/Water Interfaces: Mechanistic Aspects, and Impacts of Co-Ions, Charge Densities, and Charge Locations

Research Progress of Attapulgite's Application

Acidity of edge surface sites of montmorillonite and kaolinite

Charging properties of cassiterite (alpha-SnO(2)) surfaces in NaCl and RbCl ionic media

Competitive adsorption of alkali ions on aqueous mica surface: A force field comparison molecular dynamics study

Control of nanostructures through pH-dependent self-assembly of nanoplatelets

Probing Surface Charge Potentials of Clay Basal Planes and Edges by Direct Force Measurements

Application progress of attapulgite in the field of ceramics

Crystal Structure and Surface Property of Kaolinite in Hard Kaolins and Softkaolins