Relapse and failure rates between CAD/CAM and conventional fixed retainers: a 2-year follow-up of a randomized controlled clinical trial
Giau Tran,Ryan Rucker,Patrick Foley,Brent Bankhead,Samar M Adel,Ki Beom Kim
DOI: https://doi.org/10.1093/ejo/cjad079
IF: 3.131
2024-01-01
European Journal of Orthodontics
Abstract:Abstract Background Retention has been always considered a major challenge in orthodontics. Recently computer-aided design/computer-aided manufacturing (CAD/CAM) fixed retainers (FRs) have been introduced as a marked development in retainer technology, offering potential advantages. Objective The objective of this study was to compare the differences in relapse and failure rates in patients treated with FRs using CAD/CAM technology, lab-based technique, and chairside method. Trial design A double-blinded, prospective, randomized controlled clinical trial was conducted over a 2-year period at a single centre. Methods Participants Initially, 81 patients were recruited, but only 43 patients who came back for a 2-year retention were included in the study. Interventions These patients were divided into three groups: CAD/CAM group with multistranded Stainless Steel wires (CAD/CAM, n = 14), lab group with the same multistranded wires (lab, n = 15), and a chairside group with Stainless Steel Ortho-FlexTech wires (chairside, n = 14). Outcomes Inter-canine width (ICW) and Little’s irregularity index were digitally measured from scans at the orthodontic debonding (T1), 6-month retention (T2), 1-year retention (T3), and 2-year retention (T4) visits. All forms of failure were documented and analyzed. Randomization Participants were randomly assigned to the three groups using online randomization software (randomization.com) by a statistician who was not involved in the study. Blinding Patients were blinded in terms of the FR group to which they were each randomly assigned. The principal investigator was blinded upon data analysis since patients’ records were coded to minimize observer and measurement bias. Results Initially 81 patients were assessed for eligibility. Seventy-five patients were randomly allocated into the three study groups. After 2-year follow-up, 43 patients came back for the follow-up and were analyzed. The CAD/CAM group showed significantly less reduction in ICW compared to the chairside group at all time intervals (P < .05) and compared to the lab group at 6 months (P = .038). In terms of LII, the CAD/CAM group exhibited significantly less change than the chairside and lab groups at all time intervals (P < .05). The CAD/CAM group had the lowest failure rate (21.4%), followed by chairside group (28.6%) and then lab group (33.3%), however the differences were insignificant. No harms were observed in the current study. Conclusion Within 2 years of fixed retention, CAD/CAM FRs showed significantly less relapse than lab-based and chairside FRs. However, there was no significant difference in failure rates among the groups. Trial registration NCT05915273
dentistry, oral surgery & medicine