Abstract:Power conversion efficiency (PCE) of organic solar cells (OSCs) has reached the threshold for application. However, the high PCEs are mostly obtained from the small‐area OSCs processed by the halogenated solvent, such as chloroform (CF), because the high‐performance A‐DA'D‐A type small molecule acceptors (SMAs) need the CF processing for suitable solubility and rapid solvent evaporation to get appropriate aggregation morphology. Herein, we synthesized two new A‐DA'D‐A type SMAs of Y6‐Ph and L8‐Ph by introducing a phenyl end group in the branched alkyl inner side chains of the representative SMAs Y6 and L8‐BO respectively, for overcoming the excessive aggregation of SMAs in the long‐time film‐forming process in the nonhalogenated solvent processing. Firstly, we studied the effect of the processing solvent boiling point on the aggregation property and photovoltaic performance of the four SMAs of Y6, L8‐BO, Y6‐Ph and L8‐Ph, by using the most commonly used halogenated processing solvents: low‐boiling‐point CF (rapid film forming process) and high‐boiling‐point chlorobenzene (CB) (slow film forming process) for device fabrication of the OSCs with PM6 as polymer donor. It was found that the Y6‐ and L8‐BO‐based OSCs exhibit a dramatic drop in PCEs from CF‐ to CB‐processed devices owing to the large phase separation in the CB‐processed OSCs. On the contrary, the devices based on Y6‐Ph and L8‐Ph with the phenyl ending inner side chains show obviously increased PCEs for the OSCs processed by high‐boiling‐point CB. The L8‐Ph‐based devices processed by CB demonstrated an PCE of 18.83% with a high FF of 80.55%, which is even better than the L8‐BO‐based OSCs processed by CF. Furthermore, the L8‐Ph‐based OSCs processed by nonhalogenated solvent o‐xylene (o‐XY) also achieved a high PCE of 18.40% with an FF of 80.11%, which is the best‐performed OSC fabricated from the nonhalogenated solvents so far. In addition, the large‐area (1 cm2) OSCs based on PM6:L8‐Ph processed by o‐XY also demonstrated a higher PCE of 16.66%. The results indicate that introducing phenyl end group in the inner side chains is an effective strategy to improve photovoltaic performance of the A‐DA'D‐A SMAs for future application of the OSCs with nonhalogenated solvent processing. This article is protected by copyright. All rights reserved

Host‐Guest Active Layer Enabling Annealing‐Free, Nonhalogenated Green Solvent Processing for High‐Performance Organic Solar Cells

A guest-assisted molecular-organization approach for >17% efficiency organic solar cells using environmentally friendly solvents

Efficient and easily repeatable organic solar cells in a high boiling point solvent by introducing a highly mixed tolerant guest acceptor

Host‐Guest Strategy Enabling Nonhalogenated Solvent Processing for High‐Performance All‐Polymer Hosted Solar Cells†

Releasing Acceptor from Donor Matrix to Accelerate Crystallization Kinetics with a Second Donor Toward High‐Efficiency Green‐Printable Organic Photovoltaics

Enhancing Performances of Solution-Processed Inverted Ternary Small-Molecule Organic Solar Cells: Manipulating the Host-Guest Donors and Acceptor Interaction

Manipulating Molecular Organization in High-Efficiency Organic Solar Cells

Modulation of Crystallization Kinetics Using a Guest Acceptor for High-Performance Organic Solar Cells with 19.8% Efficiency

Asymmetric Molecule and Thermal Condition Enable Green Solvent‐Processed Organic Solar Cells Achieve 17.89% Efficiency

Oligomeric Semiconductors Enable High Efficiency Open Air Processed Organic Solar Cells by Modulating Pre-aggregation and Crystallization Kinetics

High‐Performance Green Thick‐Film Ternary Organic Solar Cells Enabled by Crystallinity Regulation

High-efficiency Organic Solar Cells Processed from a Halogen-Free Solvent System

A high-efficiency and stable organic solar cell with balanced crystallization kinetics

Achieving 10% efficiency in non-fullerene all-small-molecule organic solar cells without extra treatments

Guest-assisted Assembly Strategy: Boosting Solvent-Processed Organic Solar Cells Toward Commercialization

Non‐Fully Conjugated Dimerized Giant Acceptors with Different Alkyl‐Linked Sites for Stable and 19.13% Efficiency Organic Solar Cells

High-performance All Polymer Solar Cells Fabricated with Non-halogenated Solvent

Heterogeneous Nucleating Agent for High‐Boiling‐Point Nonhalogenated Solvent‐Processed Organic Solar Cells and Modules

Isomerization Strategy on Non-fullerene Guest Acceptor Enables Stable Organic Solar Cells over 19% Efficiency

Introducing Phenyl End Group in The Inner Side Chains of A‐Da'd‐A Acceptors Enables High‐Efficiency Organic Solar Cells Processed with Nonhalogenated Solvent

Modulating the Growth of Nonfullerene Acceptors Toward Efficient and Stable Organic Solar Cells Processed by High‐Boiling‐Point Solvents