Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Structural, Elastic, Electronic, Dynamic, and Thermal Properties of SrAl2O4 with an Orthorhombic Structure Under Pressure

Ab Initio Calculation of Structure and Thermodynamic Properties of Zintl Aluminide SrAl2

The first-principles calculations for the elastic properties of Zr2Al under compression

Plastic Deformation and Sintering of Alumina under High Pressure

Crystal Structure, Vibrational Spectroscopy, and Microwave Dielectric Properties of CaAl4O7 Ceramics with Low Permittivity

Structural, elastic, optic, and electronic properties of strontium oxide under pressure studied by first-principles calculations

Abnormal Elastic Changes for Cubic-Tetragonal Transition of Single-Crystal SrTiO3

First-principles Investigation of the Structural, Mechanical and Thermodynamic Properties of Al2Cu Phase under Various Pressure and Temperature Conditions

Electronic Structure of High-pressure Alumina Polymorphs

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Structure, pressure-induced phase transition, electronic and thermal properties of alkaline earth oxide compounds

Tuning the essential physical properties of thermodynamically stable LaAlO 3 perovskite: A first principles quantum analysis for the developments in optoelectronic devices

Novel High-Pressure Phases of Alp from First Principles

High Pressure Effects on the Crystal Structure and Electric Conductivity of Perovskite Like (ca/sr) 2 CuO 2 Cl 2 Compounds

Ab-initio Study of Phase Stability, Elastic and Thermodynamic Properties of AlY Alloy under Pressure

Properties of cubic GdAlO3 perovskite under pressure: density functional theory and Monte Carlo simulations

Electron Hybridization and Anharmonic Thermal Vibration Effect on Structure Transition of SrTiO 3 at High-Pressure and Low-Temperature

etic and electronic properties of CrO 2 at multimegabar pressures

Effects of pressure on the structural, electronic, and elastic properties of superconductor material with perovskite structure YBa2Cu3O7: insights from ab initio calculation

First-Principles Calculations of Mechanical and Thermodynamic Properties of Yalo3

Structural and mechanical properties of magnesium aluminate nanoceramics under high pressure