Abstract:In order to achieve high-fidelity PIV measurement for cross flow in rod bundles, the measurement approach with the two-dimensional (2D) PIV has been optimized systematically and the systematic and random errors are analyzed. The optimizations, covering the design of test section, the setting of optical system, the PIV parameter configuration and the PIV correlation algorithm, were established based on massive sensitivity analysis. Utilizing the optimized PIV configuration, cross flow measurements were conducted in a 5 x 5 rod bundle with the rods 9.5 mm in diameter and the rod pitch of 12.6 mm, which is the typical configuration of fuel assembly in pressurized water reactors (PWRs). The FEP tubes filled with deionized water are employed as the matched index of refraction (MIR) rods to realize uniform illumination across the rod bundle. On each investigated cross section the cross flow was measured in the 16 inner subchannels. In order to maximize the magnification factor, four subchannels are measured in a single test run. Several substantial error sources were identified and accounted for in the error and uncertainty analysis. The systematic error consists mainly of the perspective error and displacement variation error, which were quantified and used to correct the measured results. The uncertainty of RMS velocity is the combination of random error and error due to limited sampling number, while the uncertainty of mean velocity equals to the error resulted from limited sampling number assuming that the systematic error is perfectly compensated. In the experiment the relative standard uncertainty of RMS velocity (to the bulk velocity) is within 0.6%, and the relative standard uncertainty of mean velocity (to the bulk velocity) is less than 0.4%. The measurements were carried out with the subchannel Reynolds number (Re) of 39600 at five cross sections, i.e. 3D(h), 5D(h), 10D(h), 15D(h) and 20D(h) downstream of a spacer grid. The experimental results showed the detailed cross flow features, including the evolution of vortices, in the rod bundle. The measured lateral flow was substantially dominated by the mixing vanes. Drastic turbulence generation by mixing vanes was observed downstream of a spacer grid. The generated turbulence decayed rapidly within 10D(h) downstream of the spacer grid and then damped gradually.

Dual-Orthogonal-Plane Particle Image Velocimetry Measurement of the Turbulent Flow in the Channel Head of a Large-Scale Steam Generator Mock-Up

Simultaneous Measurements of Velocity and Concentration Fields in an Inclined Jet in Crossflow

Measurements of Mixing Layers and Vortex Structures of the Strut-Induced Flow in a Scramjet Combustor with PIV and POD

High-fidelity PIV Measurement of Cross Flow in 5 × 5 Rod Bundle with Mixing Vane Grids

POD and DMD Analysis of Dynamic Flow Structures in the Recirculation Region of an Unconfined Swirl Cup

Measurement on oscillatory flow at the end of the parallel-stacks using particle image velocimetry

Experimental Study on PIV Measurement and CFD Investigation of the Internal Flow Characteristics in a Reactor Coolant Pump

Experimental Study of Flow Structures in a Large Range Downstream the Spacer Grid in a 5 × 5 Rod Bundle Using TR-PIV

Time-Resolved Particle Image Velocimetry Measurements and Proper Orthogonal Decomposition Analysis of Unsteady Flow in a Centrifugal Impeller Passage

Telecentric PIV measurement of lateral flow in rod-bundle fuel assembly

Experimental study of turbulent flow in a scaled RPV model by PIV technology

Full-scale Numerical Study on the Flow Characteristics and Mal-Distribution Phenomena in SG Steam-Water Separation System of an Advanced PWR

Investigation of Unsteady Engulfment Flows in a Cross‑shaped Mixer by Particle Image Velocimetry

Flow Regime Identification of Steam-Water Two-Phase Flow Using Optical Probes, Based on Local Parameters in Vertical Tube Bundles

PIV Measurement of Turbulent Flow Downstream of Mixing Vane Spacer Grid in 5×5 Rod Bundle

Modal Decomposition Study of the Non-Reactive Flow Field in a Dual-Swirl Combustor

Experimental Investigation on Split-Mixing-vane Forced Mixing in Pressurized Water Reactor Fuel Assembly

PIV Measurement and Numerical Investigation on Flow Characteristics of Simulated Fast Reactor Fuel Subassembly

Identification of structures and mechanisms in a flow field by POD analysis for input data obtained from visualization and PIV

Experimental Study of Turbulent Flow in Lower Plenum with Flow Skirt of Reactor Pressure Vessel of Pressurized Water Reactor

CFD Simulation and High-Speed Photography of Liquid Flow in the Outer Cavity Zone of a Rotating Packed Bed Reactor