Abstract:Additional strain increments occur in concrete subject to stress constraints during cold shrinkage, resulting in irregular deformation and reducing the concrete structure’s stability. When an annular concrete structure is subjected to radial pressure, two tensile stress concentration zones will appear at the intersection of the inner wall and the diameter along the pressure direction. When exposed to low temperatures, the total strain in the tensile stress concentration zones is caused by the combined effect of applied stress strain and thermal strain. Then, the thermal strain of the structure can be obtained from the difference between the total strain and the applied stress strain. Gradient cooling was performed after applying radial pressure to the annular concrete using a counterforce device. The applied stress strain and total strain of the tensile stress concentration zones are measured by fiber Bragg grating (FBG) strain sensors fixed along the stress direction. According to the measurement results, the thermal strains of the concrete structure under the stress constraint are extracted to analyze the influence of the tensile stress constraint on the thermal strain of the concrete structure. In the temperature range of −40∘C∼20∘C, the thermal strains of the structure under radial pressures of 1500 N, 2000 N, and 3000 N are extracted, respectively. The thermal expansion coefficients are calculated based on the thermal strain of the structure. The free thermal expansion coefficient of concrete structures fluctuates around 11×10−6/∘C. When the temperature is reduced to 10∘C, the difference between the thermal expansion coefficient under the stress constraint and the free thermal expansion coefficient is the largest. When the temperature is reduced to −20∘C, the thermal expansion coefficients under each stress condition are close to the same. The results show that the stress confinement significantly inhibits the cold shrinkage of the concrete structure, and the inhibitory effect is gradually weakened when the temperature decreases.

New insights into strain evolution of concrete under different freeze-thaw conditions: Investigation based on real-time and full-field monitoring

Development of Internal Moisture Transfer and Cumulative Residual Strain in Concrete under Freeze-Thaw Cycles

Stress Analysis for Concrete Materials under Multiple Freeze-Thaw Cycles

Effect of freeze–thaw cycles on the stress–strain curves of unconfined and confined concrete

Experimental Investigation of the Deformational Behavior of the Interfacial Transition Zone (itz) in Concrete During Freezing and Thawing Cycles

Stress-strain relationship of concrete in freeze-thaw environment

Fractal modelling of freeze-thaw in cold-region concrete: quantitative micro-network evolution and hydro-thermo-mechanical assessment

Experimental studies on mechanical properties of concrete under freeze-thaw action

Thermal Strain Detection for Concrete Structure Cold Shrinkage under Stress Constraint with FBG

Influence of Flexural Loading on Chloride Ingress in Concrete Subjected to Cyclic Drying-Wetting Condition

A Numerical Study on Chloride Diffusion in Freeze-Thaw Affected Concrete

Flexural behaviour of reinforced concrete members subjected to freeze-thaw cycles

Modeling and Mesoscale Simulation of Ice-Strengthened Mechanical Properties of Concrete at Low Temperatures

Experimental Study on Mechanical Properties and Pore Structure Deterioration of Concrete under Freeze–Thaw Cycles

Flexural Behaviour of Reinforced Concrete Beams under Freeze–thaw Cycles and Sustained Load

Coupled surface-internal deformation monitoring in three-dimensional space for freezing-thawing soil

Microstructural Damage Evolution And Its Effect On Fracture Behavior Of Concrete Subjected To Freeze-Thaw Cycles

Mechanical Modeling of Frozen Coarse-Grained Materials Incorporating Microscale Investigation

Investigation of creep characteristics and microscopic mechanism of cemented-soil subjected to freeze-thaw

Three-Dimensional Mesonumerical Model of Freeze-Thaw Concrete Based on the Porosity Swelling Theory

Degradation of mechanical properties of concrete caused by freeze-thaw action