Abstract:The tight oil/gas reservoirs in China have showed the great exploration prospects and high production potential, with the characteristics of low porosity, low permeability, and significant heterogeneity in formation rocks. It remains a challenge to sort out the relations between reservoir wave responses and rock physical properties, and the further studies on the wave response patterns of tight reservoirs are in an urgent demand. The shear modulus and S- (shear) wave attenuation of rocks are affected by the properties of pore fluid and confining pressure. The ultrasonic wave experiments are performed on eight partially-saturated tight sandstone samples at different confining pressures, and we estimate S-wave attenuation with the spectral-ratio method. Results show that S-wave attenuation decreases with increasing confining pressure, and the water saturation case shows more loss compared to the oil saturation case, while the gas saturation case gives the lowest attenuation. We observe the S-wave relaxation peak at an intermediate water saturation for the gas-water partial-saturation case in general. S-wave attenuation increases with increasing porosity or permeability. Based on the measured rock physical properties, and combined with the Voigt–Reuss–Hill (VRH) average, differential effective medium (DEM) model and squirt-flow model, a tight rock attenuation model is proposed for analyzing the attenuation characteristics of fluid-saturated rocks at different confining pressures. The model reasonably describes the S-wave attenuation characteristics. The model predictions of S-wave attenuation show apparent pressure- and fluid-sensitivity at full saturation and partial saturation conditions. For sample TS1-19 at full saturation with different confining pressures, the S-wave peak attenuation predicted by the model ranges from 11.6 to 69.5, and decreases with confining pressure, while the relaxation frequency shifts to high frequency end. For the partial saturation condition of the sample, the predicted S-wave peak attenuation ranges from 15.5 to 39.8 at a confining pressure of 30 MPa and increases with water saturation, while the relaxation frequency shifts to low frequency end. For all the samples at 30MPa confining pressure, the predicted S-wave attenuation ranges from 5.6 to 38.6. At the full-saturation case, the predicted S-wave attenuation increases with porosity and decreases with confining pressure. For the partial saturation case, the S-wave attenuation predicted with the model and the Voigt and Reuss bounds generally increases with water saturation, whereas the experimentally-measured attenuation exhibits the peak attenuation at an intermediate saturation.

P- and S-wave velocities and attenuations of Naparima Hill Formation mudstones at elevated pressures

Experimental Study of Seismic Wave Attenuation in Carbonate Rocks

Effects of pressure and fluid properties on S-wave attenuation of tight rocks based on ultrasonic experiments

Empirical rock physics relationships on carbonate dry-frame elastic properties

Effects of Ellipsoidal Heterogeneities on Wave Propagation in Partially Saturated Double-Porosity Rocks

CO 2 ‐Brine Substitution Effects on Ultrasonic Wave Propagation Through Sandstone With Oblique Fractures

Controls on mechanical properties of carbonate mudstone: Insights from non-destructive techniques and geochemical data

Seismic Velocities, Poisson's Ratios and Potential Auxetic Behavior of Volcanic Rocks

Stress and frequency dependence of wave velocities in saturated rocks based on acoustoelasticity with squirt-flow dissipation

NMR-Supported Near-Wellbore Data Analysis to Improve the Petrophysical Evaluation of a Sandstone Reservoir Drilled With Barite-Enriched Water-Based Mud

Investigating the Alteration of Sandstone Pore System and Rock Features by Role of Weighting Materials

Effect of Multiscale Cracks on Seismic Wave Propagation in Tight Sandstones

Rock physics model for velocity—pressure relations and its application to shale pore pressure estimation

Sound velocity measurement methods for porous sandstone. Measurements, finite element modelling, and diffraction correction

Velocity measurement of North Sea heavy oil sands under changing pressure and temperature

An experimental study on the influence of pressure on permeability and seismic velocity in the Montserrat geothermal field (West Indies)

Comparison of P‐wave Attenuation Models of Wave‐induced Flow

Use digital rock physics to characterize velocity and attenuation signatures of deep cavity-fracture carbonate reservoirs

Modeling the effects of pore aspect ratio, porosity, and seismic anisotropy on wave velocity dispersion and attenuation patterns in oil- and brine-saturated carbonates using a dynamic self-consistent anisotropic approach

The Effect of Diagenetic Minerals on the Petrophysical Properties of Sandstone Reservoir: A Case Study of the Upper Shallow Marine Sandstones in the Central Bredasdorp Basin, Offshore South Africa

Compressional and shear wave velocities relationship in anisotropic organic shales