Abstract:Emerging organic solar cells based on a ternary strategy is one of the most effective methods for improving the blend film morphology, absorption ability, and device performances. On the other hand, this strategy has had very limited success in all-polymer solar cells (all-PSCs) because of the scarcity of new polymers and the challenges faced during third component optimization. Herein, highly efficient ternary all-PSCs were developed from siloxane-functionalized side chains with a wide-band-gap (Eg) polymer, Si-BDT, which is blended with a medium and ultra-narrow Eg polymer donor and acceptor, PTB7-Th, and DCNBT-TPIC. An impressive power conversion efficiency (PCE) of 13.45% was achieved in the ternary all-PSCs [PTB7-Th(0.6):Si-BDT(0.4):DCNBT-TPIC(0.6)] with the addition of 0.4 wt equivalent Si-BDT into binary all-PSCs [PTB7-Th(1):DCNBT-TPIC(0.6) PCE of 10.11%]. In contrast, the binary all-PSCs with a Si-BDT(1):DCNBT-TPIC(0.6) active layer only exhibited a good PCE of 9.92%. More importantly, the siloxane-functionalized side chains increase the light-absorption ability, carrier mobility, blend miscibility, and film morphology in ternary devices compared to those of the binary devices. Hence, exciton dissociation, charge carrier transport, and suppressed recombination properties were facilitated. In the presence of Si-BDT, both binary and ternary all-PSCs PCEs are significantly improved. Indeed, 13.45% PCE is one of the best values reported for all-PSCs except for those based on polymerized small molecule acceptors. In addition, the ternary all-PSCs showed excellent environmental and thermal stabilities with 95 and 84% of the initial PCE retained after 900 and 500 h, respectively. These results offer effective device engineering, providing a new avenue for improving the device performance in ternary all-PSCs.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c20542.Additional text describing experimental details (materials and measurements and characterization of the all-PSCs), SCLC, UV–vis absorption spectra, UPS analysis, efficiency histograms, J–V curves, PL spectra, EDS element mapping, contact angle, GIXRD study, and recent publications based on ternary all-PSCs (PDF)This article has not yet been cited by other publications.

Nonhalogenated Solvent-Processed Efficient Ternary All-Polymer Solar Cells Enabled by the Introduction of a Naphthyloxy Group into the Side Chain of Polymer Donors

Facile Strategy for Third Component Optimization in Wide-Band-Gap π-Conjugated Polymer Donor-Based Efficient Ternary All-Polymer Solar Cells

Nonconjugated Terpolymer Acceptors with Two Different Fused-Ring Electron-Deficient Building Blocks for Efficient All-Polymer Solar Cells

Polymer acceptor based on naphthalene diimide and diethynylbenzo[1,2-b:4,5-b'] dithiophene units for efficient all-polymer solar cells

A chlorinated polymer promoted analogue co-donors for efficient ternary all-polymer solar cells

High-performance polymer solar cells based on terpolymer composed of one donor and two acceptors processed with non-halogenated solvent

Significance of Siloxane Functionalized Side-Chain π-Conjugated Polymer Donor: Optimization of Active Layer Morphology Toward the Stable All-Polymer Solar Cells

N-alkyl chain modification in dithienobenzotriazole unit enabled efficient polymer donor for high-performance non-fullerene solar cells

Donor-acceptor (D-A) Terpolymers Based on Alkyl-Dpp and T-Bocdpp Moieties for Polymer Solar Cells

Synchronously regulating the alkyl side-chain and regioisomer of polymerized small molecule acceptor enabling highly efficient all-polymer solar cells processed with non-halogenated solvent

Highly efficient and stable binary and ternary organic solar cells using polymerized nonfused ring electron acceptors

Ternary All-Polymer Solar Cells with Two Synergetic Donors Enable Efficiency over 14.5%

Optimizing the Alkyl Side-Chain Design of a Wide Band-Gap Polymer Donor for Attaining Nonfullerene Organic Solar Cells with High Efficiency Using a Nonhalogenated Solvent

Synthesis and photovoltaic properties of D-A copolymers of benzodithiophene and naphtho[2,3-c]thiophene-4,9-dione

All-polymer Solar Cells Based on Side-Chain-isolated Polythiophenes and Poly(perylene Diimide-Alt-dithienothiophene)

Developing Halogen‐Free Polymer Donors for Efficient Nonfullerene Organic Solar Cells by Addition of Highly Electron‐Deficient Diketopyrrolopyrrole Unit

Designing a Highly Crystalline Polymer Donor with Alkylsilyl and Fluorine Substitution to Achieve Efficient Ternary Organic Solar Cells

Designing High-Performance Wide Bandgap Polymer Donors by the Synergistic Effect of Introducing Carboxylate and Fluoro Substituents

Highly Efficient Ternary All‐Polymer Solar Cells with Enhanced Stability

Improving Miscibility of Polymer Donor and Polymer Acceptor by Reducing Chain Entanglement for Realizing 18.64% Efficiency All Polymer Solar Cells

Wide Bandgap Polymer Donors Containing Dihalovinyl Thiophene Building Blocks for Organic Solar Cells