Boosting the Catalytic Performance of CuO x in CO 2 Hydrogenation by Incorporating CeO 2 Promoters

Jinhui Xu,Lingling Li,Jing Pan,Wenjie Cui,Xi Liang,Yang Yu,Bo Liu,Xiao Wang,Shuyan Song,Hongjie Zhang

DOI: https://doi.org/10.1002/adsu.202100439

IF: 6.737

2022-02-10

Advanced Sustainable Systems

Abstract:Copper is one of the most promising components in CO2 hydrogenation reactions, however, it still seriously suffers from the lower capability in CO2 activity, as well as poor durability. Herein, a novel copper‐cerium mixed metal oxide is fabricated via a controllable surface deposition route, showing excellent catalytic performance in CO2 hydrogenation. Of particular note, among the various samples with tunable Cu/Ce molar ratios, the obtained CuOx‐5CeO2 containing 0.42% Ce exhibits the highest catalytic activity with ≈31% CO2 conversion and 98% CO selectivity at 380 °C, as well as an excellent stability for 50 h. The as‐prepared catalysts are then characterized by H2‐temperature‐programmed reduction, CO2‐termperature programmed desorption, and in situ diffuse reflectance infrared Fourier transform spectroscopy to explore the possible reaction pathways. The results indicate the significance of the interactions between CuOx and CeO2, which can facilitate the activation of H2 and CO2 simultaneously, to promote the formation of formate intermediates. A cost‐efficient catalyst composed of copper oxide and ceria with precisely controlled interfaces for selectively converting CO2 into CO is reported. The enhancement can be attributed to the strong interactions between these two components, in which CeO2 plays the key role in CO2 activation and CuOx is critical in H2 activation, resulting in the highly accelerated reaction rate.

materials science, multidisciplinary,green & sustainable science & technology

What problem does this paper attempt to address?

The paper is primarily dedicated to addressing the issue of enhancing catalyst performance in the hydrogenation reaction of carbon dioxide (CO₂). Specifically, the paper focuses on the following aspects:

1. **CO₂ Activation at Low Temperatures**: Effectively activating CO₂ at relatively low temperatures is a challenge because CO₂ molecules are quite stable and difficult to activate.

2. **Product Selectivity**: Maintaining high selectivity for carbon monoxide (CO) production over a wide temperature range, rather than producing the byproduct methane (CH₄).

3. **Limitations of Copper-Based Catalysts**: Although copper-based catalysts have high CO selectivity and low cost, their catalytic activity is poor.

The paper proposes a method to address the above issues by incorporating CeO₂ as a co-catalyst into CuOₓ. The presence of CeO₂ can promote the simultaneous activation of H₂ and CO₂, thereby accelerating the formation of formate intermediates and subsequently increasing the yield of CO. Experimental results show that at 380°C, the CuOₓ-5CeO₂ catalyst exhibits a CO₂ conversion rate of up to 31% and a CO selectivity of 98%, maintaining good stability over 50 hours.